Freebox Revolution electrical panel connection

Thank you for your feedback,

Regarding the blue cable, I will look into it this evening and will get back to you.

The purpose of my approach is not necessarily to distribute Internet in all rooms; 4/5 will be more than enough, but rather to avoid leaving the box in the future baby's room that will arrive in a few months...

If I understand correctly, if I want to connect 4 out of the 5 rooms, I only need RJ45 sockets to link the RJ45 sockets from the box to the panel? So, it's not necessary to buy a switch...

Thank you in advance.

Best regards.

Hello,

This installation is only meant to distribute the phone/DSL line to all the outlets in the house.

To distribute Ethernet, the box would need to be placed in this central unit, connected to the DTI, and the Ethernet outputs from the box connected to RJ45 ports 1 to 5. You would need to add a switch since there are only 4 outputs on the box if you really want to power all the outlets in the house.

And disconnect the 4 gray cables and the blue one. Where does this one come from? We can't see it in the photo. If it’s from the back of the DTI, it was the cable to connect the DSL line to the living room where the box could be placed.

Like in this diagram:

OK,
actually you need to install your box, the ADSL unit to this cabinet.
Connect the ADSL socket to the test socket of the DTI or to one of the 5 outputs of the white/blue cables with a coupler.
And the Ethernet ports to the 5 patch panel sockets:

So you remove the spider cables and the blue cable that connects the 5 sockets and are only used to distribute the phone, and you connect the Ethernet ports of your box with appropriate RJ45 patch cords.

--
and ... Voila Voilou Voila !