NAT issue with Vuze
kissweb
-
kissweb Posted messages 5 Status Member -
kissweb Posted messages 5 Status Member -
Hello,
I am facing a NAT problem on vuze.
Indeed, the smileys next to my seeds are always yellow.
I have done a NAT/firewall test, and vuze constantly responds "NAT problem, that means the port is probably closed" for both TCP and UDP...
I have checked
-on my livebox and the corresponding port is indeed open (tcp and udp), the firewall level is set to "low",
-in comodo (my firewall), I have opened the corresponding port following a tutorial,
-finally, the Windows firewall (seven) is disabled...
I don't understand where it is blocking...
I would like to clarify that this does not affect my downloads (I have a very satisfactory speed) but it does affect my uploads... my ratio is therefore really low. and that is what bothers me..
So, I have not found any pre-existing question that addresses my problem, which is why I allowed myself to post in the forum.
Thank you in advance for all your responses :)
Configuration: Windows 7 / Firefox 18.0
I am facing a NAT problem on vuze.
Indeed, the smileys next to my seeds are always yellow.
I have done a NAT/firewall test, and vuze constantly responds "NAT problem, that means the port is probably closed" for both TCP and UDP...
I have checked
-on my livebox and the corresponding port is indeed open (tcp and udp), the firewall level is set to "low",
-in comodo (my firewall), I have opened the corresponding port following a tutorial,
-finally, the Windows firewall (seven) is disabled...
I don't understand where it is blocking...
I would like to clarify that this does not affect my downloads (I have a very satisfactory speed) but it does affect my uploads... my ratio is therefore really low. and that is what bothers me..
So, I have not found any pre-existing question that addresses my problem, which is why I allowed myself to post in the forum.
Thank you in advance for all your responses :)
Configuration: Windows 7 / Firefox 18.0
1 answer
-
Well... in my impatience, I tried to check the entire chain of participants in opening the ports.
So I started by uninstalling my Comodo firewall...
And there you go, it works again...
Comodo has a problem with opening ports... I had followed the tutorial properly...
Note to anyone who has encountered the same problem as I did: it’s Comodo!!!
Thanks