Pb config wifi sous Debian

Bonjour,

Je n'arrive pas à configurer mon wifi. J'ai essayé tellement de méthode que je commence à me demander si je suis pas en trin de me créé des problèmes plus qu'autres choses.

J'ai une carte wifi Intel PRO/Wireless 2200 ( je croie :) ) que je veux connecter avec une NeufBox. Cela fonctionnais trés bien sous windows XP.

Qq commande:

netbook:/# /sbin/iwconfig
lo no wireless extensions.

eth0 no wireless extensions.

eth2 radio off ESSID:"NEUF_7AA4"
Mode:Managed Channel:0 Access Point: Not-Associated
Bit Rate:0 kb/s Tx-Power=off Sensitivity=8/0
Retry limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

netbook:/# /sbin/ifconfig
eth2 Link encap:Ethernet HWaddr 00:12:f0:aa:4b:61
inet adr:192.168.1.3 Bcast:192.168.1.255 Masque:255.255.255.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interruption:17 Adresse de base:0xa000 Mémoire:dfcff000-dfcfffff

netbook:/# /sbin/route -n
Table de routage IP du noyau
Destination Passerelle Genmask Indic Metric Ref Use Iface
192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth2
169.254.0.0 0.0.0.0 255.255.0.0 U 1000 0 0 eth0
0.0.0.0 192.168.1.1 0.0.0.0 UG 0 0 0 eth2
0.0.0.0 192.168.1.1 0.0.0.0 UG 0 0 0 eth0

netbook:/# cat /etc/resolv.conf
nameserver 192.168.1.1

netbook:/# nslookup www.google.fr
Server: 192.168.1.1
Address: 192.168.1.1#53

Non-authoritative answer:
www.google.fr canonical name = www.google.com.
www.google.com canonical name = www.l.google.com.
Name: www.l.google.com
Address: 209.85.227.99
Name: www.l.google.com
Address: 209.85.227.147
Name: www.l.google.com
Address: 209.85.227.105
Name: www.l.google.com
Address: 209.85.227.104
Name: www.l.google.com
Address: 209.85.227.106
Name: www.l.google.com
Address: 209.85.227.103

netbook:/# ping -c2 www.google.fr
PING www.l.google.com (209.85.227.103) 56(84) bytes of data.
64 bytes from wy-in-f103.1e100.net (209.85.227.103): icmp_seq=1 ttl=54 time=54.1 ms
64 bytes from wy-in-f103.1e100.net (209.85.227.103): icmp_seq=2 ttl=54 time=54.4 ms

--- www.l.google.com ping statistics ---
2 packets transmitted, 2 received, 0% packet loss, time 1004ms
rtt min/avg/max/mdev = 54.108/54.276/54.444/0.168 ms

netbook:/# cat /etc/network/interfaces
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).

# The loopback network interface
auto lo
iface lo inet loopback

# The primary network interface
allow-hotplug eth0
iface eth0 inet dhcp

iface eth2 inet static
address 192.168.1.3
netmask 255.255.255.0
gateway 192.168.1.1
wpa-psk MACLE
wpa-driver wext
wpa-key-mgmt WPA-PSK
wpa-proto WPA
wpa-ssid MONSSID

auto eth0
auto eth2

netbook:/# cat /etc/wpa_supplicant/wpa_supplicant.conf
ctrl_interface=/var/run/wpa_supplicant
eapol_version=1
ap_scan=1
fast_reauth=1

network={
ssid="MONSSID"
scan_ssid=1
proto=WPA
key_mgmt=WPA-PSK
psk=MACLE
priority=5
}
________________________________________________________

le ping et le nslookup fonctionne par mon réseau filaire. Et si dans mon fichier interfaces, on ne vois pas la wpa_supplicant, je l'ai éssayé.

Il y as toujours cette réponse que je trouve bizar
netbook:/# iwlist eth2 scan
eth2 No scan results

Mayday