View original (French)

Printing format change issue

leleducoco Posted messages 8 Registration date   Status Member Last intervention   -  
leleducoco Posted messages 8 Registration date   Status Member Last intervention   -
Hello,

I have an A4 landscape document (see image figure 1) that I would like to print according to figure 2. How can I do that?
Thank you in advance for your responses!

1 answer

  1.
    Sergio39 Posted messages 5315 Registration date   Status Contributor Last intervention   2 622
     
    Hello,
    If the switch between portrait and landscape doesn't happen automatically when printing, you need to go to the printer options and select landscape mode, then confirm this change.
    Try again by following my advice.
    Best wishes for 2017.
    0
    1. leleducoco Posted messages 8 Registration date   Status Member Last intervention  
       
      Thank you for your response, but it's not working. By changing the orientation of the sheet, my document retains its normal size and gets cut off.
      0
      1. Sergio39 Posted messages 5315 Registration date   Status Contributor Last intervention   2 622 > leleducoco Posted messages 8 Registration date   Status Member Last intervention  
         
        Wait, I didn't look closely at your drawing.. actually, do you want to print your A4 page by cutting it in half?
        0
    2. leleducoco Posted messages 8 Registration date   Status Member Last intervention  
       
      Yes, that makes a change in the orientation of the sheet and a reduction in the document.
      0
      1. Sergio39 Posted messages 5315 Registration date   Status Contributor Last intervention   2 622 > leleducoco Posted messages 8 Registration date   Status Member Last intervention  
         
        This impression in 2 times is not possible.
        Either you print your complete sheet in landscape format or in portrait format, but you will not be able to do what is indicated in your diagram.
        0
    3. leleducoco Posted messages 8 Registration date   Status Member Last intervention  
       
      Alright, thank you, that way I’ll stop looking :-)
      I’m going to find another solution.
      0