Epson xp-202 - Wi-Fi not detected

Hello,

I am worn out so I am coming to you to find a solution.

I received a Wi-Fi all-in-one Epson XP-202 printer from Santa Claus

At home, I have:
- a Wi-Fi PC running XP 64bits
- a second Wi-Fi PC running XP 64bits
- a FreeBox V6

The FreeBox is not connected directly to the 2 PCs or the printer
Both PCs are connected to the internet without any issues and I can communicate between the two PCs as well

The printer was connected via USB to one PC and printing works.

The problem comes from the printer's Wi-Fi.
1. there is no LCD screen on the printer, I only have a Wi-Fi button that needs to be pressed for 3 seconds to establish a Wi-Fi connection. The light blinks green then orange for more than a minute and then it blinks orange
2. When I go to mafreebox.freebox.fr, the "printer" station does not appear
regardless of the Wi-Fi button's state on the printer
3. on the PCs in "view available wireless networks": the printer is not visible
4. I have a button on the printer that allows me to check the printer status. It indicates this
"General information"
MAC Address: A4:EE:57:8C:5E:FA
Software: 40.RD13CC 40(N....
Printer Model: XP-202 203 206 Series
Printer Name: EPSON8C5EFA

"Wireless"
Wireless mode: On
Communication Mode: Infrastructure
Operation Mode: IEEE802.11b/g/n
Communication Speed: 0Mbps
SSID: EpsonNet
Channel: None
Security Level: None
AP Authentication Method: Auto (Open System)
Link status: Searching
Link Down count (recent): 0
Link Down count (total): 0
Access Point (MAC Address): None
Signal Strength: No Good
SSID List: None
Configuration Method: Others
WPS-PIN Code: 58826195

"TCP/IP IPv4"
IPv4: Enable
Obtain IP Address: Unknown
IP Address: None
Subnet Mask: None
Default Gateway: None
APIPA: Enable
Acquisition way of DNS ADDR: Auto
Primary DNS Address: None
Secondary DNS Address: None

"Bonjour"
Bonjour: Enable
Bonjour Name: None
Bonjour Service Name: None

"WSD"
WSD: Enable

"SLP"
SLP: Enable

"LLMNR"
LLMNR: Enable
Host name: None

"Idle Timeout"
LPR: 300(sec)
Port9100: 300(sec)
WSD Print: 300(sec)
WSD Scan: 300(sec)

"Scan"
Network scanning: Enable

Here is the information I have!
If someone could help me, that would be great because I'm cracking up :cry:

Thank you in advance

Nini