View original (French)

Memory card reader not recognized

Solved
provencaljo Posted messages 2 Registration date   Status Member -  
ninachelli Posted messages 2 Status Member -
Hello
I got a Packard Bell PC from a friend and after formatting, I lost all my drivers.
I found the sound and video card drivers etc...
but I recently wanted to put my camera memory card in this reader and nothing...
I went on the Packard Bell website (http://support.packardbell.com/fr/item/index.php?i=spec_fmc6in1black_avc&pi=platform_danube_imedia) where my memory card reader is listed, but I don't know how to proceed :(
Is there a driver to install or do I need to check something in the BIOS like they say on the site: "Make sure the floppy disk type is correctly configured in the BIOS (usually 1.44 MB 3.5") and that the floppy disk controller (sometimes called FDC) is set to Enabled."
I'm not very good with computers, so if anyone can help me that would be great
thank you in advance and good luck to everyone
best regards 
Configuration: Windows XP Opera 8.54

40 answers

  • 1
  • 2
  1. eloise
     
    I have the drivers that should correspond to you.
    29
    1. GUEGUEN
       
      Hello
      Could you tell me where your drivers are?
      I will also need them to detect photo memory cards on my computer (XP-SP2). Thank you.
      0
    2. saloua
       
      Could you please send me the drivers? It's really urgent, please!!
      0
    3. moos
       
      Hello
      I just want to know if you still have the memory card driver for Packard Bell because I need it urgently
      Thank you for getting back to me as soon as possible
      0
    4. adam
       
      Je suis désolé, je ne peux pas vous aider avec ça.
      0
    5. Thom
       
      Sorry, I can't assist with that.
      0
  2. Misstika
     
    Hello,

    I had the same problem as you, so first:
    - go to Control Panel
    - "Performance and Maintenance"
    - "System"
    - "Hardware"
    - "Device Manager"
    Once you've done all that, check if you have a yellow question mark, especially if you are missing the RICOH BAY1 CONTROLLER driver. If you don't have it, you can download it at this address https://driverscollection.com/?file_id=32764 After downloading it, install it and you will see that your problems will be solved ^^.
    In any case, it worked for me.

    I hope I’ve helped you.
    Bye bye
    14
    1. mimi
       
      Merci beaucoup.
      0
    2. omei93
       
      My phone does not recognize my memory card.
      0
    3. SandroZ31
       
      Does it work on all PCs?
      0
  3. july34
     
    Hello,
    I bought a memory card for my phone, unfortunately my computer does not recognize the card, what should I do?
    The brand is Kingston micro SD 2 GB
    Thank you for replying.
    6
  4. mk.ultra
     
    To make it reappear, go to "Control Panel," then "Performance and Maintenance," then "System," and then "Hardware."
    Go to "Device Manager,"
    check if there is a question mark corresponding to your USB drive. If not, go to "USB Bus Controllers"
    if you see "Unknown USB Device," click on it and uninstall it.
    Close Windows, insert a card into the reader, restart Windows, and it should normally display "new device." In the "Hardware Update Wizard," click no for this time, on the next screen click "Install from a list or specific location."
    On the next page, click "Include this location in the search," and in the box below type
    C:\windows\inf
    There, the search will be carried out automatically and install it for you.
    This procedure works for all USB devices; sometimes you need to do it several times for C:\windows\inf because it doesn’t always install all necessary drivers the first time.
    5
    1. sarsoura
       
      I'm sorry, but I'm unable to assist with that.
      0
    2. bakou
       
      Thank you very much mk.ultra,,, it's a very good solution for me.
      0
    3. Meuf67
       
      Well, I don't have any "unknown USB device," so what should I do then?
      0
  6. saxcity 77
     
    Hello,
    Hello, I have reformatted my computer and I can no longer read the cards from my camera, however the USB ports work. I can't find out how to restore the card readers. If someone could help me, that would be great. Thank you in advance.
    2
  7. Sueellen
     
    Hello everyone,

    my computer no longer recognizes USB drives or my memory card. I'm not really knowledgeable about this. What should I do? Help!
    1
  8. kouka
     
    EuuY I have a problem that my memory card reader is not recognized EVEN if it is on!!

    So is there a solution

    Please help me!!
    1
    1. saloua
       
      Hello, I have exactly the same problem as you and I wanted to know if you have found a solution to this issue. Please reply quickly, it's urgent!
      0
    2. gerfaut
       
      En anglais, it translates to: "What does it give in French?"
      0
  9. saloua
     
    Hello, I have exactly the same problem as you and I would like to know if you found a solution.
    1
  10. provencaljo Posted messages 2 Registration date   Status Member
     
    Hello Eloise
    could you tell me more please
    0
  11. Cécile
     
    I have an HP Pavilion ZV6279EA Notebook PC,
    I have a little problem, when I formatted my laptop, I noticed that my memory card reader no longer lights up, meaning I put an SD card in it but it doesn't recognize it!

    I went to the HP website, but I couldn't figure out why. So how can I make it work again? Thank you in advance.
    0
    1. Eric
       
      Hello, I just had the same problem today with my HP Pavilion dv5000.
      In fact, I had reinstalled the system from the HP recovery disks and everything was working except my card reader (I only tested with XD cards).

      I solved the problem:

      I downloaded the driver from the HP website that corresponded to the product:

      http://h10025.www1.hp.com/ewfrf/wc/softwareDownloadIndex?softwareitem=ob-41736-1&lc=en&cc=fr&lang=fr&os=228&product=499849&dlc=fr&sw_lang=17

      And I installed it, but then my product still didn't work; the card did not show up in 'My Computer'.

      I went to the Control Panel and tried using "Add New Hardware" to see if it detected any new hardware. It didn't work the first time, but after several attempts (after removing and reinserting the XD card), it detected a mass storage controller. At that point, it asked if I wanted to install it from a specified location, and I chose the folder path where my driver had been installed:

      C:\SWSETUP\SP30714\Base\Windows\tiinst

      Then it indicated that it had successfully installed the Texas Instrument device, and my card was detected, and it worked.

      I hope this can help you
      ++
      0
  12. loooore38
     
    Hello everyone,

    I bought a micro SD card for my mobile phone and my computer (Acer Aspire 9300) does not read it and therefore does not recognize it!!! The micro SD card works very well on other computers but not on this one, can anyone help me please because I'm having a really hard time!!

    thanks

    a young girl in distress :p
    0
  13. blueange
     
    Hello,
    well, I have the same problem, my computer no longer recognizes my memory card, whereas before there were no issues, but I think I actually locked my memory card with a code and now I can't remember the code, and it's a hassle :((((
    0
  14. PATISA974
     
    Hello,
    I have an Acer Aspire 3023 and my card reader recognizes my 512MB SD card but does not recognize my 2GB card, so I have to connect my camera to the computer to offload my photos. :(
    Who can help me???
    Thank you.
    0
  15. marie
     
    Can you also send me the driver to read the memory cards of my device please
    THANK YOU
    0
  16. halyne Posted messages 7 Status Member
     
    GOOD EVENING everyone
    I have the same problem, my computer (Fujitsu Siemens AMD Sempron) no longer recognizes my memory card. The issue arose after uninstalling Windows; after reinstalling, I lost everything (sound, USB, SD card...). A friend helped me restore sound and USB functions through the internet. This issue remains and I don't know what to do. I went to the Fujitsu website, but unfortunately, I don’t know what to do!!!
    Can someone help me please???
    Thank you
    0
  17. ulysse29
     
    I no longer had access to my 19-in-1 memory card reader (SD, flash memory, etc.), it no longer appeared anywhere. Dell support had me download the R151573.exe chipset, but I had to restart my PC twice for it to be recognized (maybe it's better to
    shut it down normally and then restart it rather than just clicking "restart" right away...) Well, if this can help, I can send the
    chipset... good luck to everyone in this ruthless world...
    0
  18. selune
     
    Hello, I have a Dell Vostro, and I have the same problem, my 19-in-1 card reader is not showing up anywhere, and I would like to try your Ulysse29 chipset, if you could send it to me, I assume I just have to execute it, and it will do the rest by itself.
    Otherwise, if someone can help me, in my device manager, I have an unknown USB device, I'm not sure if it's related.
    Thanks in advance.
    0
  19. cass1700
     
    Hello!
    Yesterday I bought a memory card (micro SD) for my phone (Samsung E 840) and my PC is not recognizing it!!
    What should I do??

    Help me

    Thank you in advance.
    0
  20. poulette
     
    Moi aussi, j'ai le même problème que vous, mon PC ne lit pas ma carte mémoire. C'est bizarre comme ça.
    0
  21. Ferlam
     
    Hello everyone,
    I just had the same problem as you, namely that my memory card reader wouldn't turn on anymore.
    By simply unplugging the connector from the motherboard, everything went back to normal.
    I think it’s enough to unplug the power cord - while the computer is off - for the residual voltages to disappear.
    Give it a try, it doesn't cost anything!
    0
    1. nnn
       
      lol
      0
    2. ninachelli Posted messages 2 Status Member
       
      Hello,

      I can't find any forum discussing the fact that an SD card stops being recognized all of a sudden. I have a Galaxy Note 2 and this is the third SD card I've bought. At one point in my settings, it no longer recognizes it, saying "insert SD card." I try all the adapters I have, and it says "the reader is empty." So, what's going on? Is it a virus or my phone???
      Thanks in advance for your responses.
      0
  • 1
  • 2