A voir également:
- Flashage d'un modem Linkstar
- Modem usb samsung ne fonctionne pas - Forum Windows 10
- Télécharger logiciel gratuit decodage et flashage téléphone portable pour pc - Forum Mobile
- Andie veut accéder à internet dans son nouveau logement. que doit-elle faire pour avoir une box (modem) et pouvoir se connecter à internet ? - Forum câblage
- Diane - Forum Mail
- Box internet et débit ? ✓ - Forum Box Internet
1 réponse
Bonjour,
qui peut me traduire ceci:
"if you have forgotten your password for full Telnet Access, please use the following sequence and procedure to unlock the system. If your unit is under a lease agreement you may not be authorised to do this, doesn’t apply to owned devices. Make one of these cables, and open the RCST. Inside there is a serial connector to which you can connect using this cable decribed below.
Linkstar Serial Cable
Only the middle 4 pins are used (use a 4 pin connector phone plug) Looking at the phone plug with the clip facing away from you.
pin 1 goes to pin 5 on the serial connector
pin 2 goes to pin 2 on the serial connector
pin 3 goes to pin 3 on the serial connector
pin 4 not used
some loopbacks on the serial connector
7 and 8 are looped
1 and 4 are looped
6 and 4 are looped
1- connect to HUB and ask them to reset your password
2- make open linkstar case and make a cable as Viasat and connect
to serial port of your computer ,and use of hyperterimal software on
windows ,go the following steps
1- Turn on your linkstar
2- wait untill your terminal pass boos producers
3- when you reached to CLI type the following commands.
4- Type "ZAP " press enter
5- Type "Boot" press enter
6- Now your password has been reseted.
you can use the NULL password to login as root
and use the command:
"passwd -u root -p newpassword "
to reset root password"
Merci.
qui peut me traduire ceci:
"if you have forgotten your password for full Telnet Access, please use the following sequence and procedure to unlock the system. If your unit is under a lease agreement you may not be authorised to do this, doesn’t apply to owned devices. Make one of these cables, and open the RCST. Inside there is a serial connector to which you can connect using this cable decribed below.
Linkstar Serial Cable
Only the middle 4 pins are used (use a 4 pin connector phone plug) Looking at the phone plug with the clip facing away from you.
pin 1 goes to pin 5 on the serial connector
pin 2 goes to pin 2 on the serial connector
pin 3 goes to pin 3 on the serial connector
pin 4 not used
some loopbacks on the serial connector
7 and 8 are looped
1 and 4 are looped
6 and 4 are looped
1- connect to HUB and ask them to reset your password
2- make open linkstar case and make a cable as Viasat and connect
to serial port of your computer ,and use of hyperterimal software on
windows ,go the following steps
1- Turn on your linkstar
2- wait untill your terminal pass boos producers
3- when you reached to CLI type the following commands.
4- Type "ZAP " press enter
5- Type "Boot" press enter
6- Now your password has been reseted.
you can use the NULL password to login as root
and use the command:
"passwd -u root -p newpassword "
to reset root password"
Merci.
mai ca marche pas
il me renvoit comma,de non reconnu
la commande WAP et Boot
alors s'il existe une autre solution aidez moi