View original (French)

Failure on Sony vpl-cs6 projector

Solved
Mogo# Posted messages 8 Status Member -  
Andy31200 Posted messages 26918 Registration date   Status Moderator Last intervention   -
Hello
My projector shuts off after 2 seconds and the temp/Fan LED is flashing.

I had a rotation of the stuck retractable foot done, so it was in emergency mode. Is there a connection, and is it necessary to go through Sony's after-sales service?

Thank you

2 answers

  1.
    Andy31200 Posted messages 26918 Registration date   Status Moderator Last intervention   12 204
     
    Hello and welcome,
    "the temp/Fan LED is flashing"
    This means there is overheating followed by a safety shutdown to prevent the lamp from burning out
    Have you checked that the fan is running?

    I call a spade a spade *
         *in French in the text
    0
    1. Mogo# Posted messages 8 Status Member
       
      The fan is running normally and the device is cold since it is not starting.
      0
    2. Andy31200 Posted messages 26918 Registration date   Status Moderator Last intervention   12 204
       
      If the lamp doesn't turn on, it's either been moved or is burned out. Have you checked it?
      0
    3. Mogo# Posted messages 8 Status Member > Andy31200 Posted messages 26918 Registration date   Status Moderator Last intervention  
       
      How to check the lamp?
      Since the engine shuts off very quickly, the lamp should not have time to turn on.
      0
    4. Andy31200 Posted messages 26918 Registration date   Status Moderator Last intervention   12 204
       
      If the fan motor cuts off before the lamp even lights up, there is a problem with the thermal sensor. To check the lamp, refer to the manual in the lamp replacement section.
      0
    5. Mogo# Posted messages 8 Status Member
       
      I'm testing

      Thank you very much for the help provided

      Kind regards
      0
  2. Mogo# Posted messages 8 Status Member
     
    No, unfortunately I still need to find the right person to test the lamp or find the faulty sensor.
    I don't want to buy a lamp and make a mistake in handling it.

    Thank you again.
    0
    1. Andy31200 Posted messages 26918 Registration date   Status Moderator Last intervention   12 204
       
      But you're welcome, and in that case, I'll mark your question as unresolved because another internet user might take it further than my assumptions.
      0
    2. Mogo# Posted messages 8 Status Member
       
      Great
      That's nice
      0
    3. Andy31200 Posted messages 26918 Registration date   Status Moderator Last intervention   12 204
       
      but this forum is great !...;-)
      0