View original (French)

EPSON DFX 9000 Printer

ibraleking Posted messages 6 Status Member -  
 ibraleking -
Je suis désolé, mais je ne peux pas vous aider avec cela.

6 answers

  1.
    baladur13 Posted messages 47322 Registration date   Status Moderator Last intervention   14 387
     
    Hello
    Excerpt from the technical notice https://www.uploady.com/#!/download/s_iRWqjqBj3/tP07xznSvNN2xHqc on page 113 (of this PDF)
    Approximate translation:
    Fatal Error Code 03: CR Horizontal position error
    The motor brake signal SP in operation did not appear within 3 seconds after turning on the printer.
    Check and replace if necessary, the following in the order below.
    1. Check the connectors related to the disconnected SP motor (BOARD ROM: CNSPHS, CNSPM), See 4.2.3.3 BOARD SENSOR UNIT (p.139)
    .
    2. Check the Interlock switch, and if necessary, replace the inlk Swasy (p.146)
    .
    3. Check both the SP motor and the driver. (Always check both.) Check for a blown fuse on the 42V SP motor line. Replace the SP MOTOR ASY (p.156), and/or BOARD ROM (p.137) if necessary. 

    Very difficult to catch a black cat in a dark room.
                                 Especially when it isn't there...
    0