6 answers
Hello
Excerpt from the technical notice https://www.uploady.com/#!/download/s_iRWqjqBj3/tP07xznSvNN2xHqc on page 113 (of this PDF)
Approximate translation:
Fatal Error Code 03: CR Horizontal position error
The motor brake signal SP in operation did not appear within 3 seconds after turning on the printer.
Check and replace if necessary, the following in the order below.
1. Check the connectors related to the disconnected SP motor (BOARD ROM: CNSPHS, CNSPM), See 4.2.3.3 BOARD SENSOR UNIT (p.139)
.
2. Check the Interlock switch, and if necessary, replace the inlk Swasy (p.146)
.
3. Check both the SP motor and the driver. (Always check both.) Check for a blown fuse on the 42V SP motor line. Replace the SP MOTOR ASY (p.156), and/or BOARD ROM (p.137) if necessary.
Excerpt from the technical notice https://www.uploady.com/#!/download/s_iRWqjqBj3/tP07xznSvNN2xHqc on page 113 (of this PDF)
Approximate translation:
Fatal Error Code 03: CR Horizontal position error
The motor brake signal SP in operation did not appear within 3 seconds after turning on the printer.
Check and replace if necessary, the following in the order below.
1. Check the connectors related to the disconnected SP motor (BOARD ROM: CNSPHS, CNSPM), See 4.2.3.3 BOARD SENSOR UNIT (p.139)
.
2. Check the Interlock switch, and if necessary, replace the inlk Swasy (p.146)
.
3. Check both the SP motor and the driver. (Always check both.) Check for a blown fuse on the 42V SP motor line. Replace the SP MOTOR ASY (p.156), and/or BOARD ROM (p.137) if necessary.
Very difficult to catch a black cat in a dark room.
Especially when it isn't there...
