View original (French)

Erreur d’installation des pilotes IDE

Doudou Posted messages 118 Status Member -  
 ggotana -
for best reliability§ performance, please change the stand alone slave drive to master. system halt

4 answers

  1.
    oppossum Posted messages 76 Status Member 71
     
    well buddy you only have one hard drive right?
    because hard drives have little jumpers at the back to determine (depending on the jumpers' position) whether they are master or slave and if you only have one drive it must be set to master, whatever happens if you have several, the system drive should be master.
    to change that you open your PC and you change the jumper to set it to master as it should be marked on it. also be careful to have plugged the correct end of your ribbon cable onto the drive

    cf this little thread
    http://www.coupdepoucepc.com/modules/news/article.php?storyid=131
    the whole thing is very well done with illustrations and all, this is the HDD page but the whole set is not bad!
    3
    1. Doudou Posted messages 118 Status Member
       
      hello, thank you for your answer, I will read it all right away
      0
    2. Doudou Posted messages 118 Status Member
       
      f2:setup f1:boot menu auto-detecting pri master...ide hard disk auto-detecting pri slave...not detected auto detecting sec master..not detected pri master: P760A30A IBM-DPTA-372050 Ultra DMA mode-4, S.M.A.R.T capable disabled sec slave : 0100 HL-DT-STDVD-ROM GDR8161B Thank you in advance
      0
    3. Doudou Posted messages 118 Status Member
       
      f2:setup f1:boot menu auto-detecting pri master...ide hard disk auto-detecting pri slave...not detected auto detecting sec master..not detected pri master: P760A30A IBM-DPTA-372050 Ultra DMA mode-4, S.M.A.R.T capable disabled sec slave : 0100 HL-DT-STDVD-ROM GDR8161B Thank you in advance
      0
  2. insomniak Posted messages 1544 Status Member 196
     
    hi!

    did you change the hard drive or is it the same one (sorry I didn’t quite understand)?
    anyway if you didn’t change it, it should already be in “master” position so...

    try F1 to see if your HDD is set to first boot

    that said, changing the motherboard implies reinstalling the operating system.
    --
    me gusta jugar con el tío sam
    0
  3. laura
     
    I have a problem helping me my computer will stop at this window IDE drive installation error for best reliability and performance please change the stand alone slave drive to master system halt
    0
  4. kati
     
    When I start my PC AND IT DOES 2 BEEPS AND IT WRITES IDE DEVICE #0 ERROR WHAT SHOULD I DO
    0
    1. ggotana
       
      very simple to solve if the hard drive and the drive are on the same cable, set the hard drive to master and the drive to slave if the hard drive and the drive are on two different cables, set the hard drive to master on its cable and set the drive to master on its cable I had this problem and I solved it this way.
      0