Problème Carte Wifi non détecté sur Ubuntu [Résolu/Fermé]

 j3rom3 -
voila je viens d'installer ubuntu mais le wifi ne marche pas.
J'ai trouvé un tuto pour mon problème:

I used the above thread to do my work - banged my head against the wall a couple of times but it was fun . I am listing down steps that finally worked for me. But before that, my configurations:
Ubuntu 10.10
64 bit
WPA2 wireless network
OS was freshly installed and there was no specific customization prior to this
RaLink Device 5390. (use lspci to see your model number)
Download the driver from -> Software -> Linux
Unzip the download zip file anywhere. I did it in the default Downloads directory
cd to the 2010_xxx extracted directory
cd os/linux/
Edit the file as below:
HAS_ATE=y (no change, it was originally as is)
HAS_WPA_SUPPLICANT=y (no change, it was originally as is)
HAS_NATIVE_WPA_SUPPLICANT_SUPPORT=y (no change, it was originally as is)
HAS_ANTENNA_DIVERSITY_SUPPORT=y originally was n -- this was the only thing I modified)
Go back to the 2010_xx directory
run command 'make'
Make sure 'make compile' exists without errors. I got an error "too many arguments to format" towards the end of the compile but it did compile successfully eventually. And so I ignored the errors. You would see ***errors*** if the compile is not successful. In which, something went wrong and you may need to tweak the makefile or files before compile is successful.
run command 'make install' as root. This is not listed in the README_STA_pci file that comes with downloaded driver zip file. This takes of copying the file to /lib/modules/2.6.35-22-generic/kernel/drivers/net/wireless/rt5390sta.ko. running depmod, creating /etc/Wireless/... folder.
Edit the /etc/modules and add the line at the end of this file
Edit the file /etc/modprobe.d/blacklist.conf and add the below line to it...
blacklist rt2800pci
Reboot and you should see an ra0 interface when you run the command 'ifconfig'
You may have to run '/etc/init.d/network-manager restart' command to have it show in the first go.
Once, the wireless icon shows up, look for your wireless SSID and there you go surfing

Mais je suis bloqué a l'étape 7 quand je tape "make"
j'ai le message : "make:*** No targets specified and no makefile found"
Pouvez-vous m'aider ?

1 réponse

Messages postés
Date d'inscription
mardi 6 mai 2008
Dernière intervention
19 avril 2020
Déplace toi dans le dossier approprié par la commande

cd (pour change directory) ou est ce que tu veux compiler.

Exemple : admettons que tu crées un dossier mon wifi dans ton home

Cela donnera

cd /home/toto/mon wifi

tu valides par enter

Et là tu fais ton make etc ...