A voir également:
- ERREUR SYSTEME E100
- Restauration systeme windows 10 - Guide
- Comment refaire le système d'un ordinateur - Guide
- Parametre systeme - Guide
- Erreur t32 ✓ - Forum Livebox
- Une erreur s'est produite instagram ✓ - Forum Instagram
2 réponses
bonjour desolé pour le retard j'ai trouve ceci mais en anglais sur se maime forum
E010 A specific revolution is not detected from the main motor rotation detection signal (MLOK*), causing the sign
Possible cause: The main motor (M101) is faulty. The controller PCB is faulty.
E100 When the scanner motor is started up, the BD input signal does not arrive within a specific period of time.
When the scanner motor is started up, the motor rotation is too fast, and fails to reach a specific revolution within 20 sec at time of deceleration.
While the scanner motor is rotating at a specific speed, the BD input signal cycle is not within a specific range (±2%) for an equivalent of 10 mm (print distance).
While the scanner motor is rotating at a specific speed, the BD input signal cycle is not as indicated (±2%).
During the WMUPR period after the power switch has been turned on or the front cover/left cover has been opened/closed, the drum unit is absent.
Possible cause: The wiring is faulty (short circuit, open circuit). The laser scanner unit is faulty. The DC controller PCB is faulty. The drum unit is not installed.
en esperant sa vous sert
cordialement
sussi
E010 A specific revolution is not detected from the main motor rotation detection signal (MLOK*), causing the sign
Possible cause: The main motor (M101) is faulty. The controller PCB is faulty.
E100 When the scanner motor is started up, the BD input signal does not arrive within a specific period of time.
When the scanner motor is started up, the motor rotation is too fast, and fails to reach a specific revolution within 20 sec at time of deceleration.
While the scanner motor is rotating at a specific speed, the BD input signal cycle is not within a specific range (±2%) for an equivalent of 10 mm (print distance).
While the scanner motor is rotating at a specific speed, the BD input signal cycle is not as indicated (±2%).
During the WMUPR period after the power switch has been turned on or the front cover/left cover has been opened/closed, the drum unit is absent.
Possible cause: The wiring is faulty (short circuit, open circuit). The laser scanner unit is faulty. The DC controller PCB is faulty. The drum unit is not installed.
en esperant sa vous sert
cordialement
sussi
