5 réponses
Hello,
I'm also looking for how to set the channels on my TV with a Siplec Rc61 remote control.
I found that by pressing set and 9 together and then the blue button, you access the channel search, but after that, I can't figure out how to save the channels to the desired number... (like channel 2 to number 2...)
Does anyone know how to do it??
Thank you in advance for your help.
I'm also looking for how to set the channels on my TV with a Siplec Rc61 remote control.
I found that by pressing set and 9 together and then the blue button, you access the channel search, but after that, I can't figure out how to save the channels to the desired number... (like channel 2 to number 2...)
Does anyone know how to do it??
Thank you in advance for your help.
Have you solved your problem Jacky?
I have a tip for you that works on almost all TVs (works without a code!!)
1] First, reset your remote control to "zero":
Press the "set" button and the "zero" button at the same time (the "power" button light should start blinking)
2] Then perform an automatic setup and not with a code!
To do this, follow these steps:
Turn on your TV (it must be on any channel, definitely not in standby!!)
Press the "set" and "tv" buttons at the same time until the "power" button light starts blinking (about every 2 seconds).
Point your remote control at your TURNED ON television and wait for your TV to turn off (this may take several minutes)
As soon as it turns off, immediately press any button - except "power" - to turn your television back on.
Once it's back on, your remote control will be set.
There you go.
I have a tip for you that works on almost all TVs (works without a code!!)
1] First, reset your remote control to "zero":
Press the "set" button and the "zero" button at the same time (the "power" button light should start blinking)
2] Then perform an automatic setup and not with a code!
To do this, follow these steps:
Turn on your TV (it must be on any channel, definitely not in standby!!)
Press the "set" and "tv" buttons at the same time until the "power" button light starts blinking (about every 2 seconds).
Point your remote control at your TURNED ON television and wait for your TV to turn off (this may take several minutes)
As soon as it turns off, immediately press any button - except "power" - to turn your television back on.
Once it's back on, your remote control will be set.
There you go.
Hello, thanks for the information, except for the SIPLEC RC61 remote control? The button to press is actually the enter button which is located just above the scan button with an arrow.
Thanks again for the information provided, it took me a little while to figure out which button I needed to activate, as it is identical to the enter button on a computer, it wasn’t complicated.
Thanks again for the information provided, it took me a little while to figure out which button I needed to activate, as it is identical to the enter button on a computer, it wasn’t complicated.
HERE ARE ALL THE POSSIBLE CODES FOR YOUR TELEVISION SETS:
https://aerofun40.wordpress.com/!BB558D3BCB3962C4!2046.entry
HAVE FUN!
https://aerofun40.wordpress.com/!BB558D3BCB3962C4!2046.entry
HAVE FUN!
Here is the direct link for the Siplec RC61 notice
https://aerofun40.wordpress.com/!BB558D3BCB3962C4!2046
That's it for the info.
https://aerofun40.wordpress.com/!BB558D3BCB3962C4!2046
That's it for the info.
Best regards