View original (French)

Siplec RC61 Remote Control

cascadeuse -  
Hello,

I'm looking for what the buttons on the SIPLEC RC61 universal remote correspond to, so I can adjust the channels on the television.
Please help me, I'm struggling.

Thank you very much
Configuration: Windows XP Firefox 2.0.0.12

5 answers

  1. graindemais
    Hello,
    I'm also looking for how to set the channels on my TV with a Siplec Rc61 remote control.
    I found that by pressing set and 9 together and then the blue button, you access the channel search, but after that, I can't figure out how to save the channels to the desired number... (like channel 2 to number 2...)

    Does anyone know how to do it??

    Thank you in advance for your help.
    1. zinzin
      If you have found a technique for "putting" the chain back in place, it would be cool to share it since I'm in the same situation as you.
      Best regards
  2. solution
    HERE ARE ALL THE POSSIBLE CODES FOR YOUR TELEVISION SETS:

    https://aerofun40.wordpress.com/!BB558D3BCB3962C4!2046.entry

    HAVE FUN!
    2. mickael da silva
      I have already been but this is a blog, why doesn't it show the codes for the TV? Thank you for responding.
    3. koi
      Have you found it since?
      I have the manual, tell me what brand of television it is and I'll send it to you afterwards.
    4. lady sabri
      Has anyone figured out how to set up the channels finally?? Because I'm in the same situation. I've set up my remote but I can't find a way to adjust my channels! :(
    5. Jacky Leggs
      Hello, I found the code, I entered it but the keys don't correspond (for example, when I press the 1 key, it lowers the volume, etc...) the keys are reversed. How can I fix this problem?
      If you've been in the same situation as me and it's now resolved, please help me!
  4. Posthume
    Have you solved your problem Jacky?

    I have a tip for you that works on almost all TVs (works without a code!!)

    1] First, reset your remote control to "zero":
    Press the "set" button and the "zero" button at the same time (the "power" button light should start blinking)

    2] Then perform an automatic setup and not with a code!
    To do this, follow these steps:
    Turn on your TV (it must be on any channel, definitely not in standby!!)
    Press the "set" and "tv" buttons at the same time until the "power" button light starts blinking (about every 2 seconds).
    Point your remote control at your TURNED ON television and wait for your TV to turn off (this may take several minutes)
    As soon as it turns off, immediately press any button - except "power" - to turn your television back on.
    Once it's back on, your remote control will be set.

    There you go.
    1. marco 57
      <bravo to="" you="" is="" addressed="" poshtume="" thank="" again.="" marco57="" />
    2. claude
      Hello, thanks for the information, except for the SIPLEC RC61 remote control? The button to press is actually the enter button which is located just above the scan button with an arrow.
      Thanks again for the information provided, it took me a little while to figure out which button I needed to activate, as it is identical to the enter button on a computer, it wasn’t complicated.