Hard drives disabled in BIOS
Potca_kjbeeprod
-
Judge_DT Posted messages 644 Registration date Status Modérateur Last intervention -
Judge_DT Posted messages 644 Registration date Status Modérateur Last intervention -
Hello everyone, today I'm really happy because I finished building my computer...
Everything was going well, the installation was perfectly executed on my SSD. I started to install the driver for my graphics card, all went smoothly, then I began to install the driver for my motherboard, and being in a hurry, I didn't read anything at all; I just know that I checked two boxes: one for my HDD marked "slow" and one for my SSD marked "fast"
Well, up to this point, everything is fine; it asked me to reboot my PC, which I did, but at startup, the screen remained on the MSI logo. I decided to reboot it again, but still nothing, so I went into the BIOS, and there was my surprise when I saw my two hard drives disabled, and it's impossible to reactivate them, so now I'm stuck; I don't know what to do.
Thanks in advance
My config:
Ryzen 7 2700
MSI B450 Gaming Plus
Radeon RX 580
8GOx2 Crucial Ballistix Sport LT 3000MHz
Kingston SSD A400 240GO
Barracuda 1TO
Everything was going well, the installation was perfectly executed on my SSD. I started to install the driver for my graphics card, all went smoothly, then I began to install the driver for my motherboard, and being in a hurry, I didn't read anything at all; I just know that I checked two boxes: one for my HDD marked "slow" and one for my SSD marked "fast"
Well, up to this point, everything is fine; it asked me to reboot my PC, which I did, but at startup, the screen remained on the MSI logo. I decided to reboot it again, but still nothing, so I went into the BIOS, and there was my surprise when I saw my two hard drives disabled, and it's impossible to reactivate them, so now I'm stuck; I don't know what to do.
Thanks in advance
My config:
Ryzen 7 2700
MSI B450 Gaming Plus
Radeon RX 580
8GOx2 Crucial Ballistix Sport LT 3000MHz
Kingston SSD A400 240GO
Barracuda 1TO
They're both marked as disabled in the BIOS
This has nothing to do with the fact that it gets stuck on startup; this is normal for it to be disabled. You need to configure the storage in a compatible way (often only in RAID) to be able to enable HotPlug.
You should first check which ports are disabled by the M.2, just in case it's those ports and the M.2 has switched to SATA mode, which would cause them to be disabled...