TV connected to decoder box turns on and off by itself
LoukaN
Posted messages
2
Status
Membre
-
LoukaN Posted messages 2 Status Membre -
LoukaN Posted messages 2 Status Membre -
Hello,
I have a Samsung LE26C450 television connected via an HDMI port to a Free decoder for a few years now. Up until now, there have been no issues, and the Free remote controlled the power on and off for both devices. For the past week, I have been experiencing problems. First, the television started switching sources during use (switching from HDMI to TV), and I had to reset it to the correct source with its remote. This lasted for 24 hours, then the television remained on the correct source but started turning itself off and on randomly. For the past few days, this issue has mostly disappeared, but it no longer turns off. When I turn it off with the Free remote, the decoder turns off, and the TV shows the HDMI source and signals no signal. After a few minutes, it turns off by itself and then turns back on (if I turn it off manually, because it does not respond to its remote, it turns back on by itself). I have to unplug it at night. I am having difficulty accessing the television settings, particularly Anynet+, which I wanted to disable. Is my television broken, or is it a settings issue?
Thank you if you can help me.
I have a Samsung LE26C450 television connected via an HDMI port to a Free decoder for a few years now. Up until now, there have been no issues, and the Free remote controlled the power on and off for both devices. For the past week, I have been experiencing problems. First, the television started switching sources during use (switching from HDMI to TV), and I had to reset it to the correct source with its remote. This lasted for 24 hours, then the television remained on the correct source but started turning itself off and on randomly. For the past few days, this issue has mostly disappeared, but it no longer turns off. When I turn it off with the Free remote, the decoder turns off, and the TV shows the HDMI source and signals no signal. After a few minutes, it turns off by itself and then turns back on (if I turn it off manually, because it does not respond to its remote, it turns back on by itself). I have to unplug it at night. I am having difficulty accessing the television settings, particularly Anynet+, which I wanted to disable. Is my television broken, or is it a settings issue?
Thank you if you can help me.
2 réponses
Thank you for the response, but this problem has been resolved, I don't know by what miracle, maybe by repeatedly putting it back on the correct source? The issue now is that it no longer goes into standby. When I turn off the TV decoder, it stays on and after a few seconds continuously turns off and on again.
