Radio DX-AR-320
Solved
Kildinee
-
Mathieu59 -
Mathieu59 -
Hello,
I have a radio, DX-AR-320, I can't figure out how to save a radio station,
Do you know how to do it?
Thank you.
Configuration: Android / Chrome 69.0.3497.100
I have a radio, DX-AR-320, I can't figure out how to save a radio station,
Do you know how to do it?
Thank you.
Configuration: Android / Chrome 69.0.3497.100
3 réponses
Hello,
I had the same problem with the DXAR320 and I just found out!!
1- Choose which memory to add a station: press the button at the bottom left "BND AMS", select between 3 memory groups, then use the arrow buttons to the right of the volume to select a number from 1 to 6.
2- Choose the frequency of your station: press the volume button three times in a row and "CH" should appear on the screen. Then, turn the volume knob to the right and at that point, "STEP" should appear.
3- Choose your frequency step by step (step in English!) with the arrows to the right of the volume.
4- Repeat step 2... Why? Well, because otherwise it would be too easy! So press the volume button again until you reach CH, then turn the volume to the right so that STEPS is displayed, and finally press the right arrow button (the one at the top) for two seconds. And there, miracle, the frequency blinks, so it is saved!!!
5- Repeat all these steps for each station, be careful not to forget step 1, otherwise you will overwrite already programmed memories...
Hoping this will be useful!
Julien
I had the same problem with the DXAR320 and I just found out!!
1- Choose which memory to add a station: press the button at the bottom left "BND AMS", select between 3 memory groups, then use the arrow buttons to the right of the volume to select a number from 1 to 6.
2- Choose the frequency of your station: press the volume button three times in a row and "CH" should appear on the screen. Then, turn the volume knob to the right and at that point, "STEP" should appear.
3- Choose your frequency step by step (step in English!) with the arrows to the right of the volume.
4- Repeat step 2... Why? Well, because otherwise it would be too easy! So press the volume button again until you reach CH, then turn the volume to the right so that STEPS is displayed, and finally press the right arrow button (the one at the top) for two seconds. And there, miracle, the frequency blinks, so it is saved!!!
5- Repeat all these steps for each station, be careful not to forget step 1, otherwise you will overwrite already programmed memories...
Hoping this will be useful!
Julien
Kildinee
Posted messages
4
Status
Membre
Thank you very much for your help, I will try this weekend, I hope it works!!
Maurice
It doesn't work, too bad it's not mentioned in the manual.
Kildinee
Posted messages
4
Status
Membre
It’s woooooorking, thank you so much to you!!!
