View original (French)

Philips TV stuck in digital mode at startup

niko -  
 niko -
Hello,

my Philips TV 20PFL5522D/12 always defaults to digital mode when I turn it on, whereas before it would go directly to the last selected source (HDMI 1 or EXT 3).

I've searched, but I can't find how to prevent it from going directly to digital mode.

Thank you

Configuration: Windows / Firefox 61.0

5 answers

  1.
    MPMP10 Posted messages 47333 Registration date   Status Member Last intervention   18 957
     
    Hello,
    Turn on one of the devices connected to HDMI sources 1 or Ext 3 before turning on the television...

    --
    The enemy is stupid: he thinks we are the enemy while he is the one!

    Pierre Desproges
    3
  2. niko
     
    Hello,

    I've already tried and I always end up in digital mode.
    0
    1. MPMP10 Posted messages 47333 Registration date   Status Member Last intervention   18 957
       
      Don't you receive TNT on this television?
      0
  3. niko
     
    I only use it to play on the console.
    0
    1. MPMP10 Posted messages 47333 Registration date   Status Member Last intervention   18 957
       
      OK, because I looked online and this TV is not able to receive digital terrestrial television without a digital terrestrial adapter...

      Otherwise, check that the cables are properly plugged in.
      0
    2. Niko
       
      The cables are properly connected
      Is it a TV setting, but which one?
      0
      1. MPMP10 Posted messages 47333 Registration date   Status Member Last intervention   18 957 > Niko
         
        Look in the menu to reset the television...
        0
    3. Niko
       
      Doesn't work, I can't reset it...
      0
  4. niko
     
    No one has the solution, I have 3 TVs, 2 of which are 20 inches and one is 23 inches, all the same model, and one of them doesn't boot properly :/

    How can I reset it to factory settings?
    0
    1. MPMP10 Posted messages 47333 Registration date   Status Member Last intervention   18 957
       
      If it doesn't start, it's impossible to reset it...
      For the others, refer to the manual...
      0
  6. niko
     
    It works fine except that one is stuck in digital mode when I turn it on, I have to change the channel while the other 2 boot up fine on the last selected channel.

    It must be set up or stuck in digital mode but I can't reset it properly,

    I tried the trick of turning on the TV and holding the menu button on the TV for 20 seconds to reset it but it didn't work,

    by the way, when I press the menu button on the TV nothing happens.
    0
    1. adam2010
       
      Hello,
      Try to completely disconnect (eliminate) the SCART cable and then test!
      0
    2. niko
       
      Does anyone have an idea?
      0