View original (French)

New Optex decoder turns on and off.

muche01 Posted messages 15 Registration date   Status Member Last intervention   -  
muche01 Posted messages 15 Registration date   Status Member Last intervention   -
Hello,
I just changed my faulty TNT Sat decoder. When I replace it with a new model, after completing the installation, the decoder turns on and off by itself every two seconds. I have already exchanged it twice at my store for another new device, and it's always the same thing. Any idea on how to resolve this issue? Thanks in advance.

Configuration: Windows 7 / Chrome 52.0.2743.116

1 answer

  1.
    Andy31200 Posted messages 26918 Registration date   Status Moderator Last intervention   12 201
     
    Hello,
    Before proceeding with the installation, check in the menu that the 5-volt antenna power supply is properly disabled

    --
    I call a spade a spade *
    *in French in the text
    0
    1. muche01 Posted messages 15 Registration date   Status Member Last intervention  
       
      Thank you for this response. But when should I check, in the menu on my old installation or when I’ve installed the new decoder? And once again, thank you for this responsiveness.
      0
    2. Andy31200 Posted messages 26918 Registration date   Status Moderator Last intervention   12 201
       
      In the Optex menu, have you also tried to reset to factory settings?
      0
      1. muche01 Posted messages 15 Registration date   Status Member Last intervention   > Andy31200 Posted messages 26918 Registration date   Status Moderator Last intervention  
         
        I just looked in the Optex menu, I didn't see where we can "turn on - off" the 5-volt antenna power supply. And no, I haven't tried the "RESET" yet.
        0