Samsung LE32R86BD red LED blinks

Grom59380 Posted messages 6 Status Member -  
 tonio -
Hello everyone, like many people, I'm having trouble with my Samsung LE32R86BD TV. It stopped turning on overnight. The only thing that happens is the red LED next to the power button blinks and the blue light strip under the TV is on.
I saw on the forums that there are often mentions of "bulging" capacitors problems, but after disassembling and examining the power board, I don't see any capacitors that seem defective. Do you think I should still replace all the capacitors (there are apparently 7 of them that are usually involved in this kind of failure)?
I’m attaching photos of the board in question and a close-up of the capacitors.
What do you think?
Thank you for your help

7 answers

  1. guluc Posted messages 134 Status Member 40
     
    Hello
    the 6 + 1 small one on the right side of the 1st photo is marked bigger with a blue pencil. Be careful with the voltage; it should have one or more capacitors, I believe, of 15v, to be replaced with the same voltage as the others.
    And for the TVs and screens, it's a power supply issue, so the capacitors are often faulty.
    I have other small tips, but I would be going off-topic.
    21
    1. Grom59380 Posted messages 6 Status Member
       
      Thank you for your reply Guluk, I placed my order last night but I got everything at the same voltage. Part of my order has already been shipped. I will keep you updated if it works or not after the replacement.
      Thank you

      --
      0
    2. Grom59380 Posted messages 6 Status Member
       
      Here is the received CD, I have resoldered the new capacitors and then reconnected it to the mains and .......still the same problem, no change. Do you have another idea, or should I resign myself to taking it to the dump?

      --
      0
      1. guluc Posted messages 134 Status Member 40 > Grom59380 Posted messages 6 Status Member
         
        Are you sure you have respected the polarity and put the correct capacitors? What is the value of the capacitors in microfarads?
        -1
      2. Grom59380 > guluc Posted messages 134 Status Member
         
        Hello, I just checked the polarity of each capacitor, it's okay, we can't go wrong; the + and - are identified on the board. As for the capacitors changed, there are 470, 820, 1000 (x4), and 2200. I also checked the soldering. Then I just saw that there was a fuse on the board, but I don't have a multimeter to test it. I'm going to rig up a "tester" with a battery and a bulb.
        0