Lost the universal remote control manual

AUTOMATIC CODE SEARCH SETUP

1- Turn on the device you want to set up.
2- Point the remote control at the device
3- Press the device type button (TV, DVD, VCR, ...) that you want to set.
4- Press and hold the SET button until the LED stays on continuously.
5- Press and release the Power button. The LED will first turn off and then blink once every 3 seconds.
Note: During the search, you can press UP or DOWN to change the direction of the search.
6- When the device turns off, press the OK button to store the code.
7- Check that all the buttons work correctly. If not, start again from step 3.
Note: During the search, you can press any button (except OK, UP, DOWN) to cancel.

--
I call a spade a spade...