Universal remote control user manual
Solved
universal remote TOTAL CONTROL
Hello. I am looking for the manual for a universal remote
of the brand TOTAL CONTROL. Thank you for your help
Hello. I am looking for the manual for a universal remote
of the brand TOTAL CONTROL. Thank you for your help
Configuration: Windows XP AOL 9.0
7 answers
-
Hello,
In response regarding the total control remote:
the operation is very similar to the One for All remotes for which you can easily download the manual from their website oneforall-int.com
1 - press the button for the desired device (TV, VCR, DVD, AUX,...)
2 - press and hold the setup button. the LED blinks 2 times
3 - enter the code 991. the LED blinks 2 times
4 - point the remote control towards the device
5 - alternately press the + button (to change channels) and the standby button
6 - when the device goes into standby, press and hold SETUP, the LED blinks 2 times and the code is saved.
do not hesitate to press + and standby up to 200 times.
to note the code found by the remote control:
1 - press the button for the desired device (TV, VCR, DVD, AUX,...)
2 - press and hold the setup button. the LED blinks 2 times
3 - enter the code 990. the LED blinks 2 times
4 - successively press the keys 1-2-3 and 4 on the remote and note each time the number of blinks (from 0 to 9) of the LED to reconstruct the device code.-
ContributorHello,
That matches exactly what is on the notice indicated in post 5, and it has the advantage of being in French.
One detail though: the standby button is called Power.
While you're at it, could you add the translation of the direct code entry method found in this notice! (As well as the list of those codes)
;-)
--
To err is human, to persevere is diabolical. -
-
Contributor@ptgas76Laziness? The answer exists in two of the previous posts!
--
To err is human, to persist is diabolical. -
Hello, I don’t know the brand of my TV because it's quite old and the brand has faded... ;-( But the brand of my remote control is called "CHACON" (but the O is a circle with two small balls) I don't know what to do... Thanks in advance because I've placed an article... but without a response... :-s
-
Thank you Futura,
As you say, it's the same as one for all, even the code is the same 991.
I had programmed the "One for All" remote for my mom's TV but some buttons were not working.
So I swapped my "Total Control" remote with my mom's "One for All."
Her remote works fine, but for mine, I have to press pause to get the DVD-XBOX output.
I'm going to try to find a solution to fix the DVD button with the symbol on the remote. But I don't mind having this little shortcoming.
Thanks again for your advice, which has been very helpful.
Interface Failure Chair-Keyboard DICC
-