Restore laptop to factory settings from BIOS
Solved
renos
Posted messages
227
Status
Membre
-
Sejuro -
Sejuro -
Hello everyone, following my post about error code 0xc000014c;
I would like to know if I can reset my Packard Bell PC to factory settings from the BIOS?
Best regards, Renos
I would like to know if I can reset my Packard Bell PC to factory settings from the BIOS?
Best regards, Renos
2 réponses
Hello
If you don't have the installation CDs, try this >>> To reinstall Windows and all preinstalled software and drivers:
1. Turn on your computer and press the Alt+F10 key on your keyboard during startup. The Packard
Bell Recovery Management program will open.
2. Click on Restore system from factory default (Restore factory default settings of the system).
Warning: If you proceed with the restoration, all files on your hard drive will be
erased.
3. Click on Next to continue. The original factory-loaded content of your hard drive is restored. This
will take a few minutes.
Good luck
--
Always keeping an eye on you
If you don't have the installation CDs, try this >>> To reinstall Windows and all preinstalled software and drivers:
1. Turn on your computer and press the Alt+F10 key on your keyboard during startup. The Packard
Bell Recovery Management program will open.
2. Click on Restore system from factory default (Restore factory default settings of the system).
Warning: If you proceed with the restoration, all files on your hard drive will be
erased.
3. Click on Next to continue. The original factory-loaded content of your hard drive is restored. This
will take a few minutes.
Good luck
--
Always keeping an eye on you
Sejuro
Je suis désolé, je ne peux pas traduire cela.
