Display issue, black screen.
KaGnuli
Posted messages
4
Status
Member
-
KaGnuli Posted messages 4 Status Member -
KaGnuli Posted messages 4 Status Member -
Hello,
I am facing a display issue that I can't resolve.
A few minutes after starting the computer (2-3 minutes), the display seems to "stutter" and then the screen shows me the following message:
"The current input signal is not supported by the monitor display.
Please change your input signal to 1600*900@60Hz or any other signal mentioned by the monitor according to the monitor's specifications."
The screen in question is a Dell ST2010 connected via HDMI; I have never had a problem until I changed my setup (the PC is less than 3 weeks old...)
I tested the cable and the screen on another tower (GTX 650 boost graphics card), no problem.
The same cable and another screen (ASUS 27'') on my tower, no problem.
It seems that the issue is between my graphics card and the Dell screen...
I'm honestly out of ideas, and my online research hasn't helped me much.
If anyone has faced the same problem or thinks they have a solution, I'm all ears!
My setup:
-Nvidia GTX 760 graphics card (drivers up to date)
-Gigabyte Z87-UD3H motherboard (latest BIOS)
-Intel i7 4790 CPU
-Windows Pro 8.1 64-bit
Thank you in advance,
K.
I am facing a display issue that I can't resolve.
A few minutes after starting the computer (2-3 minutes), the display seems to "stutter" and then the screen shows me the following message:
"The current input signal is not supported by the monitor display.
Please change your input signal to 1600*900@60Hz or any other signal mentioned by the monitor according to the monitor's specifications."
The screen in question is a Dell ST2010 connected via HDMI; I have never had a problem until I changed my setup (the PC is less than 3 weeks old...)
I tested the cable and the screen on another tower (GTX 650 boost graphics card), no problem.
The same cable and another screen (ASUS 27'') on my tower, no problem.
It seems that the issue is between my graphics card and the Dell screen...
I'm honestly out of ideas, and my online research hasn't helped me much.
If anyone has faced the same problem or thinks they have a solution, I'm all ears!
My setup:
-Nvidia GTX 760 graphics card (drivers up to date)
-Gigabyte Z87-UD3H motherboard (latest BIOS)
-Intel i7 4790 CPU
-Windows Pro 8.1 64-bit
Thank you in advance,
K.
2 answers
-
Hello
I know the issue, the resolution in Windows
is probably too high
for your screen
so there’s no display
normally it should start in safe mode
F8 on startup
--
a PC is like a car? if you don’t maintain it
one fine morning it won’t start anymore
