View original (French)

Add a blur area to an image

Solved
takumo Posted messages 181 Status Member -  
takumo Posted messages 181 Status Member -
Hello, I would like to know how to create a blurry area in an image using PhotoFiltre.

Thank you in advance.

3 answers

  1.
    Luke1 Posted messages 18751 Registration date   Status Contributor Last intervention   5 435
     
    Good evening

    In this case, it creates a blur over the entire image and not just a part (an area).
    For a specific area (or part), you need to either select what you want to blur, then apply a blur that you like either in Filter --> Blur where there are several types of blurs, or in Blurs --> Optical Effect where there are others. If you want to apply a blur to the entire image and only keep a part sharp, you make your selection, invert the selection, apply your blur, mask the selection, and in the area where the selection was, use a slight touch of the brush tool to ensure that the hard edge left by the selection is not visible even if it is softened... http://ioj.com/v/fnjua

    Luke.

    --
    The price of software is inversely proportional to its usability...
    (Takuan Soho 1573 - 1645 ...)
    2
    1. transat Posted messages 31956 Registration date   Status Contributor Last intervention   9 021
       
      Hello Luke
      It's a shame you blurred "the apples"
      They're going to say: Another apple story :-))
      0
    2. Luke1 Posted messages 18751 Registration date   Status Contributor Last intervention   5 435
       
      Good evening Transat,

      I was in the middle of doing something else and I only had these apples on hand.... xDD

      Have a good rest of the evening.

      Best regards;

      Luke.
      0