Samsat 560 Twin Tuner Receiver Manual

Hello
I have a Samsat 560 dual tuner receiver. I have a problem setting up the Samsat 560 USB+1 CA digital satellite receiver. How can I set it up? Thank you.

Uh well,
The site isn't too bad, but it's okay, the satellite dish fixed itself about 2 hours after I posted the flash on June 20, 2010. How can we include this in a post please for anyone else who might have the same issue?

To obtain AB1 (12.5°W), you need to set the frequency to: 12545 MHz, polarity: H, Symbol Rate: 17455. Rotate the dish until you get a signal. AB1 is the satellite that connects to the morebox decryption module integrated into one of the samasat tuners. The cable coming from the dish (AB1) should go to the input at the top left of the samsat when looking at it from the back. The other input at the top is for other satellites from which we watch channels. I think it's simple, but it requires a bit of teaching.

Bonjour, si tu as un Samsat 560 double tuner et que tu as le problème de saut de canal et des difficultés pour régler ton Samsat, ne t'inquiète pas, j'ai eu le même problème. Comme beaucoup d'autres, sers-toi de la télécommande. Je sais que ce n'est pas évident quand ça déconne, mais nous sommes tous passés par là. Après un moment, le problème disparaît tout seul, un jour ou deux. Bon courage.

Here's how to proceed:
Just do a ((factory reset)) for your receiver, then reload your favorite satellite channels and everything will be back to normal. You will have a stabilized receiver just like you had during the first reception.

Hi
for the signal of AB1, set the frequency to 11428 kHz H, symbol rate to 30000, and adjust your dish.

You're welcome.