TSX Denied Error Message
Automatix
-
Valentine_et_Laurent Posted messages 1 Registration date Status Member -
Valentine_et_Laurent Posted messages 1 Registration date Status Member -
Hello,
I have an error message on the console when I want to transfer the EEPPROM program to the RAM of a TSX17
TSX refusal even though the controller is in stop and the switch behind the cartridge is on read only?
What does this message mean?
I have an error message on the console when I want to transfer the EEPPROM program to the RAM of a TSX17
TSX refusal even though the controller is in stop and the switch behind the cartridge is on read only?
What does this message mean?
Configuration: Windows XP Internet Explorer 7.0
2 answers
Normally, the transfer occurs automatically if the program
TSX is different from the program in EEPROM. After powering
on the TSX.
TSX is different from the program in EEPROM. After powering
on the TSX.
Attention, this operation must be performed while powered off
The small switch is behind the memory cartridge.
The RAM (volatile memory) is identical to the EEPROM (non-volatile and reprogrammable memory) so if I understand correctly, the transfer cannot take place between the programming console and the TSX17-20?????
Is the cord connected to the serial port and is it a Télémécanique brand cable?
The small switch is behind the memory cartridge.
The RAM (volatile memory) is identical to the EEPROM (non-volatile and reprogrammable memory) so if I understand correctly, the transfer cannot take place between the programming console and the TSX17-20?????
Is the cord connected to the serial port and is it a Télémécanique brand cable?