View original (French)

Problem, I no longer have a channel with my AMTC decoder

ena05 Posted messages 10 Status Member -  
thomas2802 Posted messages 485 Registration date   Status Member Last intervention   -
Hello,

For several months my decoder hasn’t been working... I have no channels at all. First I checked that all the wires are properly connected; I even replaced one!! How can I get the channels back???
Thank you for your help!!

11 answers

  1.
    ena05 Posted messages 10 Status Member 3
     
    How to perform this chain scanning?
    3
  2. thomas2802 Posted messages 485 Registration date   Status Member Last intervention   83
     
    Hello,

    Have you performed a new channel scan? Especially with the new TNT channel frequencies, it is necessary to perform this new scan, hoping that your model accepts the new HD frequencies.

    Best regards
    1
  4. ena05 Posted messages 10 Status Member 3
     
    Thank you
    0
  6. thomas2802 Posted messages 485 Registration date   Status Member Last intervention   83
     
    You're welcome ;)
    0
  7. ena05 Posted messages 10 Status Member 3
     
    Well I was on the site and it’s a bit of Chinese to me, I don’t understand anything… So what should I do? Sorry to waste your time ^^
    0
  8. thomas2802 Posted messages 485 Registration date   Status Member Last intervention   83
     
    No, you’re not going to waste my time, but I don’t see how you can help me further, I’ve never had a personal outdoor antenna, being in an apartment.

    But I suppose that this antenna must be aimed toward the receiver closest to you. And by connecting the antenna to your TV, you’ll be able to perform a new scan of the channels.
    0
  9. ena05 Posted messages 10 Status Member 3
     
    I am also in an apartment!! but how to do the sweep? Because the site you indicated I don’t understand!!!
    0
  10. thomas2802 Posted messages 485 Registration date   Status Member Last intervention   83
     
    Well, normally if you’re in an apartment, it shouldn’t pose any problems (unless the collective antenna hasn’t been repositioned properly, in which case you’ll need to address the building management).

    Otherwise, the scanning is when you use your TNT decoder, you go to settings / memorization of new channels

    On the other hand, it’s possible that your adapter doesn’t receive the new high-definition channels, in which case if you want to enjoy these channels, you’ll need to invest in new equipment.
    0
  11. ena05 Posted messages 10 Status Member 3
     
    I just did the scan and still nothing!!
    0
  12. thomas2802 Posted messages 485 Registration date   Status Member Last intervention   83
     
    Hello,

    I think this means that your collective antenna is not properly repositioned toward the receiver closest to you in order to receive the new TNT channel frequencies, so you should contact your building's management or the person in charge, such as the doorman.

    Best regards
    0