Sharp AR-5316E Error code H4
cdp3
Posted messages
77
Status
Member
-
abdellah elmoutaki -
abdellah elmoutaki -
Hello,
please help me, I have a SHARP AR-5316E photocopier, and for some time now an error code has been appearing, the H4 code; in fact, this code is blinking, the letter H and the number 4 are blinking simultaneously.
Thank you in advance.
Configuration: Windows XP / Firefox 3.6.13
please help me, I have a SHARP AR-5316E photocopier, and for some time now an error code has been appearing, the H4 code; in fact, this code is blinking, the letter H and the number 4 are blinking simultaneously.
Thank you in advance.
Configuration: Windows XP / Firefox 3.6.13
2 answers
after several searches on the internet I found this solution:
performing a Fault Reset 14 will reset your machine and will help to clear error codes.
1. Find the pink Clear button on the Control Panel.
2. Find the button below the word Auto.
3. Press these buttons in the following sequence: [Clear], [Auto], [Clear], [Auto] NOTE: All of the lights on the Control Panel should go out and the LED Display should go blank. If the lights do not go out, then repeat step 3 until they do. It may be necessary to increase or decrease the pace of the [Clear], [Auto], [Clear], [Auto] sequence.
4. Press the [10's] key one time and the [1's] key four times to enter '14' in the LED Display, as if you were to make 14 copies.
5. Press the green [Start] button.
6. Press the pink [Clear] button two times.
7. The machine should now warm up and come to ready.
8. If the above steps do not clear the error code, repeat steps 3 to 6 a second time.
performing a Fault Reset 14 will reset your machine and will help to clear error codes.
1. Find the pink Clear button on the Control Panel.
2. Find the button below the word Auto.
3. Press these buttons in the following sequence: [Clear], [Auto], [Clear], [Auto] NOTE: All of the lights on the Control Panel should go out and the LED Display should go blank. If the lights do not go out, then repeat step 3 until they do. It may be necessary to increase or decrease the pace of the [Clear], [Auto], [Clear], [Auto] sequence.
4. Press the [10's] key one time and the [1's] key four times to enter '14' in the LED Display, as if you were to make 14 copies.
5. Press the green [Start] button.
6. Press the pink [Clear] button two times.
7. The machine should now warm up and come to ready.
8. If the above steps do not clear the error code, repeat steps 3 to 6 a second time.
For error code H4, press the hash key, then interrupt, then C, then interrupt, then 14, and finally OK.
The code will disappear and your copier will be functional.
Thank you!
My problem is the display of H2. Please help me!