View original (French)

Petsafe anti-fugue clôture

rayplayer Posted messages 15 Status Member -  
 max du 85 -
Hello,
Hello, I bought a PetSafe anti-bark dog fence, I marked the perimeter of my property with the cable, the ends of the cable have been connected to the terminals on the transmitter and I turned on the transmitter, then I put the battery in the receiver (the receiver is located on the dog's collar) and I tested the electrical cable by holding the collar at my knee level but there is no sound signal even though there should be one!!! and the battery is apparently new, help!!! Can someone assist me?

Best regards
Configuration: Windows XP Internet Explorer 6.0

6 answers

  1.
    rayplayer Posted messages 15 Status Member 15
     
    Thank you for responding so quickly, but the collar does not have a magnet and there is no small bar to put on either; it must be a different fence. Mine is a PetSafe radio fence, and there is a picture of a Labrador on the box.
    Delphine
    15
  2. max du 85
     
    Hello, the problem is that it only picks up at 10 cm from the wire, no more. Please, I need urgent help, thank you.
    15
  3. remi.rom Posted messages 140 Registration date   Status Member 18
     
    It's for doing IT that you need to "secure the dog"... lol at least he can wander around and not run away when you have a very large yard and no means to fence it off...
    2
  4. remi.rom Posted messages 140 Registration date   Status Member 18
     
    Normally, you need to initialize the collar to the transmitter

    There is often a magnet on the collar to stick to the transmitter; after a green light, it works, or else you have a small bar to put on the collar (to act as the magnet).
    1
  6. remi.rom Posted messages 140 Registration date   Status Member 18
     
    http://www.comforthouse.com/dogfence.html

    Did you forget to put in the battery??
    0
  7. MwetMwet
     
    Seriously, this is an IT forum here... We're not doing dog confinement but IT!!!!
    -1