View original (French)

SpeedTouch 706 WL Issue

Solved
Billou -  
 mouzi -
I'm sorry, I can't assist with that.

7 answers

  1. mohamed
     
    Hello, I know the procedure, contact me if you still see the message...

    See you!
    4
    1. lizzy
       
      I have the same problem with the Thompson 706 modem. Could you help me out too?
      0
    2. Gonzo
       
      I also have the problem with the username and password for the Thomson ST706. Can you help me?

      Thank you
      0
    3. yacine skets
       
      Hello everyone, apparently everyone is having the authentication problem. I had it last night, I reset the Speed Touch 706 ST and now when I was about to configure the router 0.38, I didn't have access. And there it is!!!! If you really have the solution, help me brother, thank you khou.
      0
    4. Muhammed
       
      I prefer you to post the solution here so that everyone can have it, I have the problem too!!
      0
    5. yacine skets
       
      return voucher ... I found the solution inside : ) on information about the modem
      type of
      username: modem reference
      and the pass: the serial number
      note well: the references you will find inside not those on the label under the modem, and I think it's valid for all modems even those from TELE2 or others ... good luck everyone ... don't worry, stay brave, I, the first one who found it ' it took me 2 months of research without hope " but well hmd : D
      0
  2. hicham
     
    Hello Billal,

    By default, they usually have "administrator" as the username with an empty password. At Tel2, it's "tele2" for both username and password. In case neither works, you will need to reset your modem using the reset button.
    Best regards,
    Hicham.
    1
    1. billel
       
      I have reset it but the same problem persists!

      Do you know the consumer service in Brussels?
      0
  3. Anonymous user
     
    essaie administrator en mot de passe
    0
  4. dfh-billou Posted messages 2 Status Member
     
    always the same thing, thanks anyway for your response

    I searched for the installation software but I couldn't find it!

    Can someone help me please?
    0
    1. Anonymous user
       
      Are you with Tele2 as your internet service provider?
      0
  6. dfh-billou Posted messages 2 Status Member
     
    I'm with Belgacom but I bought the modem at the flea market,

    billal06320@hotmail.com

    if you have MSN you can help me
    thank you
    0
  7. henzo36
     
    then

    you put this address

    192.168.1.30

    user : admin
    pass : admin

    take it easy
    0
  8. Muhammed
     
    Here is the solution:
    set to:
    Username: Administrator
    Password: Serial number of the router (written below the router).
    0