Un processeur inconnu détecté, une mise à jour du BIOS est nécessaire pour libérer tout son potentiel
ElTacos222
Posted messages
3
Status
Member
-
fabul Posted messages 42158 Registration date Status Moderator Last intervention -
fabul Posted messages 42158 Registration date Status Moderator Last intervention -
Hello
I dismantled my computer to clean it (I did not remove the CPU or the heatsink) and when I turned it back on, a page appears with "unknown CPU detected, BIOS update is required to unleash its full" written on it, and then it shuts down after 15 seconds. I then went to check the forums, and I installed the latest BIOS version on a USB drive. But when I turn on the computer, I still see the same message and cannot access the BIOS.
Thank you in advance
I dismantled my computer to clean it (I did not remove the CPU or the heatsink) and when I turned it back on, a page appears with "unknown CPU detected, BIOS update is required to unleash its full" written on it, and then it shuts down after 15 seconds. I then went to check the forums, and I installed the latest BIOS version on a USB drive. But when I turn on the computer, I still see the same message and cannot access the BIOS.
Thank you in advance
4 answers
-
Hello,
It says that there is a USB overcurrent detected.
Disconnect the USB devices.
It says CMOS Checksum BAD.
You can perform a Clear CMOS.
1. In principle, this involves disconnecting the power supply on the 230V side.
2. Remove the CR2032 battery.
3. Short-circuit two pins marked CLR_CMOS for about 10 seconds.
Either use a jumper to temporarily move, or use a screwdriver.
4. Stop short-circuiting.
5. Reinsert the CR2032 battery.
6. Reconnect the power supply.
7. Start the computer.