Adresse ip inconnue
Résolu
noctambule28
Messages postés
35799
Statut
Webmaster
-
noctambule28 Messages postés 35799 Statut Webmaster -
noctambule28 Messages postés 35799 Statut Webmaster -
bonjour
sous ubuntu avec un DELL OPTIPLEX GX260
je cherche une explication
la premiere destination est mon rooteur
mais la deuxieme( je nesait pas à quoi cela corespond )
voila j'ai pensée à ma carte reseau mais je suis debutant et plein de chose m'echappe
franck@planteur:~$ /sbin/route -n
Table de routage IP du noyau
Destination Passerelle Genmask Indic Metric Ref Use Iface
192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
169.254.0.0 0.0.0.0 255.255.0.0 U 1000 0 0 eth0
0.0.0.0 192.168.1.1 0.0.0.0 UG 0 0 0 eth0
franck@planteur:~$
avec la commande suivante HD
franck@planteur:~$ sudo dmesg | grep hd[a-z]
Password:
[ 24.803771] SCSI device sda: 39102336 512-byte hdwr sectors (20020 MB)
[ 24.812299] SCSI device sda: 39102336 512-byte hdwr sectors (20020 MB)
[ 31.057168] SCSI device sdb: 625142448 512-byte hdwr sectors (320073 MB)
[ 31.061166] SCSI device sdb: 625142448 512-byte hdwr sectors (320073 MB)
[ 46.963972] e1000: eth0: e1000_watchdog: NIC Link is Up 100 Mbps Full Duplex
et avec SD à la place de hd il ne semble plus apparaitre
franck@planteur:~$ sudo dmesg | grep sd[a-z]
[ 24.803771] SCSI device sda: 39102336 512-byte hdwr sectors (20020 MB)
[ 24.804316] sda: Write Protect is off
[ 24.804320] sda: Mode Sense: 00 3a 00 00
[ 24.808347] SCSI device sda: write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[ 24.812299] SCSI device sda: 39102336 512-byte hdwr sectors (20020 MB)
[ 24.815732] sda: Write Protect is off
[ 24.815735] sda: Mode Sense: 00 3a 00 00
[ 24.819733] SCSI device sda: write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[ 24.819738] sda: sda1 sda2 sda3 < sda5 >
[ 24.874170] sd 0:0:0:0: Attached scsi disk sda
[ 31.057168] SCSI device sdb: 625142448 512-byte hdwr sectors (320073 MB)
[ 31.058240] sdb: Write Protect is off
[ 31.058244] sdb: Mode Sense: 17 00 00 00
[ 31.058246] sdb: assuming drive cache: write through
[ 31.061166] SCSI device sdb: 625142448 512-byte hdwr sectors (320073 MB)
[ 31.062232] sdb: Write Protect is off
[ 31.062235] sdb: Mode Sense: 17 00 00 00
[ 31.062238] sdb: assuming drive cache: write through
[ 31.062241] sdb: sdb1 sdb2 sdb3 sdb4
[ 31.069283] sd 2:0:0:0: Attached scsi disk sdb
[ 31.076158] sd 3:0:0:0: Attached scsi removable disk sdc
[ 52.124851] EXT3 FS on sda2, internal journal
[ 86.056401] EXT3 FS on sdb2, internal journal
[ 86.252639] NTFS-fs warning (device sdb3): parse_options(): Option utf8 is no longer supported, using option nls=utf8. Please use option nls=utf8 in the future and make sure utf8 is compiled either as a module or into the kernel.
[ 86.665732] NTFS-fs warning (device sdb1): parse_options(): Option utf8 is no longer supported, using option nls=utf8. Please use option nls=utf8 in the future and make sure utf8 is compiled either as a module or into the kernel.
[ 86.820930] EXT3 FS on sdb4, internal journal
franck@planteur:~$
sous ubuntu avec un DELL OPTIPLEX GX260
je cherche une explication
la premiere destination est mon rooteur
mais la deuxieme( je nesait pas à quoi cela corespond )
voila j'ai pensée à ma carte reseau mais je suis debutant et plein de chose m'echappe
franck@planteur:~$ /sbin/route -n
Table de routage IP du noyau
Destination Passerelle Genmask Indic Metric Ref Use Iface
192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
169.254.0.0 0.0.0.0 255.255.0.0 U 1000 0 0 eth0
0.0.0.0 192.168.1.1 0.0.0.0 UG 0 0 0 eth0
franck@planteur:~$
avec la commande suivante HD
franck@planteur:~$ sudo dmesg | grep hd[a-z]
Password:
[ 24.803771] SCSI device sda: 39102336 512-byte hdwr sectors (20020 MB)
[ 24.812299] SCSI device sda: 39102336 512-byte hdwr sectors (20020 MB)
[ 31.057168] SCSI device sdb: 625142448 512-byte hdwr sectors (320073 MB)
[ 31.061166] SCSI device sdb: 625142448 512-byte hdwr sectors (320073 MB)
[ 46.963972] e1000: eth0: e1000_watchdog: NIC Link is Up 100 Mbps Full Duplex
et avec SD à la place de hd il ne semble plus apparaitre
franck@planteur:~$ sudo dmesg | grep sd[a-z]
[ 24.803771] SCSI device sda: 39102336 512-byte hdwr sectors (20020 MB)
[ 24.804316] sda: Write Protect is off
[ 24.804320] sda: Mode Sense: 00 3a 00 00
[ 24.808347] SCSI device sda: write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[ 24.812299] SCSI device sda: 39102336 512-byte hdwr sectors (20020 MB)
[ 24.815732] sda: Write Protect is off
[ 24.815735] sda: Mode Sense: 00 3a 00 00
[ 24.819733] SCSI device sda: write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[ 24.819738] sda: sda1 sda2 sda3 < sda5 >
[ 24.874170] sd 0:0:0:0: Attached scsi disk sda
[ 31.057168] SCSI device sdb: 625142448 512-byte hdwr sectors (320073 MB)
[ 31.058240] sdb: Write Protect is off
[ 31.058244] sdb: Mode Sense: 17 00 00 00
[ 31.058246] sdb: assuming drive cache: write through
[ 31.061166] SCSI device sdb: 625142448 512-byte hdwr sectors (320073 MB)
[ 31.062232] sdb: Write Protect is off
[ 31.062235] sdb: Mode Sense: 17 00 00 00
[ 31.062238] sdb: assuming drive cache: write through
[ 31.062241] sdb: sdb1 sdb2 sdb3 sdb4
[ 31.069283] sd 2:0:0:0: Attached scsi disk sdb
[ 31.076158] sd 3:0:0:0: Attached scsi removable disk sdc
[ 52.124851] EXT3 FS on sda2, internal journal
[ 86.056401] EXT3 FS on sdb2, internal journal
[ 86.252639] NTFS-fs warning (device sdb3): parse_options(): Option utf8 is no longer supported, using option nls=utf8. Please use option nls=utf8 in the future and make sure utf8 is compiled either as a module or into the kernel.
[ 86.665732] NTFS-fs warning (device sdb1): parse_options(): Option utf8 is no longer supported, using option nls=utf8. Please use option nls=utf8 in the future and make sure utf8 is compiled either as a module or into the kernel.
[ 86.820930] EXT3 FS on sdb4, internal journal
franck@planteur:~$
A voir également:
- Adresse ip inconnue
- Ethernet n'a pas de configuration ip valide - Guide
- Comment connaître son adresse ip - Guide
- Adresse mac - Guide
- Darkino nouvelle adresse - Guide
- Adresse ip - Guide
oh j'avais oublié de precisé que je suis debutant( 5 jours avec ubuntu)et 2mois avec win
DSN FAI je sait pas ce que c'est
si tu peu m'éclairé c'est avec plaisir
quand a la commande ifconfig voilà:
ranck@planteur:~$ sudo ifconfig
Password:
eth0 Lien encap:Ethernet HWaddr 00:08:74:1B:AA:1D
inet adr:192.168.1.11 Bcast:192.168.1.255 Masque:255.255.255.0
adr inet6: fe80::208:74ff:fe1b:aa1d/64 Scope:Lien
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
Packets reçus:12091 erreurs:0 :0 overruns:0 frame:0
TX packets:10996 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:100
Octets reçus:13439222 (12.8 MiB) Octets transmis:1424344 (1.3 MiB)
Adresse de base:0xecc0 Mémoire:ff8e0000-ff900000
lo Lien encap:Boucle locale
inet adr:127.0.0.1 Masque:255.0.0.0
adr inet6: ::1/128 Scope:Hôte
UP LOOPBACK RUNNING MTU:16436 Metric:1
Packets reçus:4 erreurs:0 :0 overruns:0 frame:0
TX packets:4 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:0
Octets reçus:276 (276.0 b) Octets transmis:276 (276.0 b)
je voulais savoir à quoi ceci correspond
46.963972] e1000: eth0: e1000_watchdog: NIC Link is Up 100 Mbps Full Duplex
a+
j'ai eu les reponse à mes questions
sauf savoir pourquoi tu trouvais mon dsn bizarre
pas grave
a+