ETTD et ETCD

yoni -  
Bonjour,

nous avons 2 routeurs cisco 2600 interconnectés l'un sur l'autre en Serial Interface 0/0.
je ne sais pas quel est l'ETTD ou l'ETCD sur chacun de ces routeurs, et j'ai pas très bien saisi ce que c'etait.

Merci

3 réponses

  1.  brupala
    salut,
    ça tu ne le verras pas bien sur le routeur: les ports série font les 2.
    en fait c'est le type de câble via un signal précis sur une des Pin qui inverse l'interface:
    etcd = dce = interface émulant un modem
    ettd = dte = interface émulant un terminal.
    en gros à part émission / réception inversés sur les 2 ainsi que les autres signaux de commande cts/rts/dcd/dtr/dsr les horloges sont émises par un etcd et reçues par un ettd (sauf le 113).
    mais on peut voir le type de l'interface (forcé par le câble) dans un show interface.
    aussi:
    un câble synchrone dte a une prise mâle en principe tandis que le câble dce a une prise femelle (comme un modem, ça tombe bien) .
    2
    1. yoni
      voici ce que j'ai lorsque je fais un show interface: 

      
enzo#show interface
Serial0/0 is up, line protocol is up
  Hardware is HD64570
  Internet address is 192.168.1.1/27
  MTU 1500 bytes, BW 1544 Kbit, DLY 1000 usec, rely 255/255, load 1/255
  Encapsulation HDLC, loopback not set, keepalive set (10 sec)
  Last input 00:00:00, output 00:00:00, output hang never
  Last clearing of "show interface" counters never
  Queueing strategy: fifo
  Output queue 0/40, 0 drops; input queue 0/75, 0 drops
  5 minute input rate 1000 bits/sec, 2 packets/sec
  5 minute output rate 1000 bits/sec, 2 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     0 input packets with dribble condition detected
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier
     0 output buffer failures, 0 output buffers swapped out
Serial1/0 is up, line protocol is up
  Hardware is HD64570
  Internet address is 192.168.1.126/27
  MTU 1500 bytes, BW 1544 Kbit, DLY 1000 usec, rely 255/255, load 1/255
  Encapsulation HDLC, loopback not set, keepalive set (10 sec)
  Last input 00:00:00, output 00:00:00, output hang never
  Last clearing of "show interface" counters never
  Queueing strategy: fifo
  Output queue 0/40, 0 drops; input queue 0/75, 0 drops
  5 minute input rate 1000 bits/sec, 2 packets/sec
  5 minute output rate 1000 bits/sec, 2 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     0 input packets with dribble condition detected
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier
     0 output buffer failures, 0 output buffers swapped out
FastEthernet0/0 is up, line protocol is up
  Hardware is Lance, address is 000C.3782.8690 (bia 000C.3782.8690)
  Internet address is 192.168.1.129/27
  MTU 1500 bytes, BW 100000 Kbit, DLY 1000 usec, rely 255/255, load 1/255
  Encapsulation ARPA, loopback not set, keepalive set (10 sec)
  Auto-duplex, Auto Speed, 100BaseTX/FX
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:00:00, output 00:00:00, output hang never
  Last clearing of "show interface" counters never
  Queueing strategy: fifo
  Output queue 0/40, 0 drops; input queue 0/75, 0 drops
  5 minute input rate 1000 bits/sec, 2 packets/sec
  5 minute output rate 1000 bits/sec, 2 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     0 input packets with dribble condition detected
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier
     0 output buffer failures, 0 output buffers swapped out
      0

      Discussions similaires

      ETTD / ETCD
      NINOU

      14 réponses