View original (French)

Ethernet connection issue impossible

Driss-rami Posted messages 13 Status Member -  
brupala Posted messages 111148 Registration date   Status Member Last intervention   -
Hello,
When I run an ipconfig/renew or release, I get this result:

"The operation failed because no adapter is in the permitted status for this operation"

When I run an ipconfig/all I don't get much:

"Host name................pc
Primary DNS suffix............:
Node type...................Hybrid
IP routing enabled...............No
WINS Proxy enabled...............No
The Ethernet adapter is available (media is enabled) but IPv4 and IPv6 are not connected in the status despite setting the IP addressing. I don't know what to do anymore... Can you help me?

4 answers

  1.
    brucine Posted messages 24882 Registration date   Status Member Last intervention   4 175
     
    Hello,

    Turn off the box, turn it back on, and try again.

    If that’s not enough and it's a laptop, go to device manager, network adapter, network driver, properties, power management: disable sleep mode.

    If that fails, try resetting the connection settings from a command prompt or Powershell in administrator mode:

    netsh interface ip
    netsh winsock reset
    netsh advfirewall reset
    netsh int ip reset
    ipconfig /release
    ipconfig /renew
    ipconfig /flushdns

    If that still doesn’t work, update the network adapter drivers or reinstall them.

    If there's a general failure, revert to a restore point if one exists, or perform a recovery or reset of Windows after backing up personal data.
    1
    1. Driss-rami Posted messages 13 Status Member
       
      My brother, I use VMware ESXi.
      0