1 réponse
jeannets
Posted messages
28340
Registration date
Status
Contributeur
Last intervention
Ambassadeur
6 597
Hello,
-- Have you checked the manual for the meaning of this error code?
-- Have you unplugged the wall socket for 5 minutes and then plugged it back in?
-- The electronic board may be faulty, but there's nothing we can do about it through this forum.
-- The head movement sensors might be dirty; there are two of them... Horizontal movement, it's a transparent plastic ribbon with fine engravings stretched between the right and left sides and running through the head... It needs to be cleaned thoroughly with a slightly damp clean cloth.
-- The vertical paper feed movement is a transparent disk with fine engravings, attached to the axes of the rollers that feed the paper, usually on the left side; it also needs cleaning.
-- It might also be that the whole printer needs cleaning; it would do it good.
Here are some points to check carefully.
-- Have you checked the manual for the meaning of this error code?
-- Have you unplugged the wall socket for 5 minutes and then plugged it back in?
-- The electronic board may be faulty, but there's nothing we can do about it through this forum.
-- The head movement sensors might be dirty; there are two of them... Horizontal movement, it's a transparent plastic ribbon with fine engravings stretched between the right and left sides and running through the head... It needs to be cleaned thoroughly with a slightly damp clean cloth.
-- The vertical paper feed movement is a transparent disk with fine engravings, attached to the axes of the rollers that feed the paper, usually on the left side; it also needs cleaning.
-- It might also be that the whole printer needs cleaning; it would do it good.
Here are some points to check carefully.
thank you for your feedback, I have already checked these points except for the detectors, I will try
have a good day