Small issue Digitec WR30M
nono444555
Posted messages
157
Registration date
Status
Membre
Last intervention
-
Ramses -
Ramses -
Hello, I have a Digitec watch WR30M and after the time change it hasn't adjusted (I think that's normal). But the problem is that I lost the manual for the watch and I don't remember how to set the time for my watch. I don't know if my watch is in manual 1, 2, 4, 5, 6, 7, 8 and none of the manuals are correct, only the one for my watch but I can't remember which one it is, the watch information is STAINLESS STEEL BACK WATER RESIST 30M. Thank you for any help.
1 réponse
Hello,
- Press the "mode" button once = access to the timer
(To start or stop the timer press "start", to reset it, press "reset")
- Press the "mode" button a second time = alarm setting
Set the alarm time by pressing "start" and switch to minute setting by pressing "reset"
- Press the "mode" button a third time = hour setting
The seconds will blink, pressing "reset" will set them to zero
- Press "reset" for minute setting and the "start" button to adjust them.
- Press "reset" to set the hour and adjust with the "start" button
- Press the "reset" button to set the day with the "start" button.
- Press the "reset" button to set the month with the "start" button.
- Press the "mode" button = end of settings
There is a 12H/24H display mode
To switch from one display mode to another, just scroll through the hours during the setting, you will see that if, for example, you are in 12H mode at 1:00 AM and you continue scrolling through the hours, you will move (among other things) to 01:00 PM and then to 24H display after 00:00.
Have fun!
You're welcome,
- Press the "mode" button once = access to the timer
(To start or stop the timer press "start", to reset it, press "reset")
- Press the "mode" button a second time = alarm setting
Set the alarm time by pressing "start" and switch to minute setting by pressing "reset"
- Press the "mode" button a third time = hour setting
The seconds will blink, pressing "reset" will set them to zero
- Press "reset" for minute setting and the "start" button to adjust them.
- Press "reset" to set the hour and adjust with the "start" button
- Press the "reset" button to set the day with the "start" button.
- Press the "reset" button to set the month with the "start" button.
- Press the "mode" button = end of settings
There is a 12H/24H display mode
To switch from one display mode to another, just scroll through the hours during the setting, you will see that if, for example, you are in 12H mode at 1:00 AM and you continue scrolling through the hours, you will move (among other things) to 01:00 PM and then to 24H display after 00:00.
Have fun!
You're welcome,
It works, by looking a bit, but it's fine while slaloming, thank you.