View original (French)

Pioneer VSA-E03 amplifier hookup and Blu-ray TV?

Taliesin56 Posted messages 45 Status Member -  
Taliesin56 Posted messages 45 Status Member -
Hello,

I’m asking for your help because I have devices of different generations and I’m not sure how to connect them to get the most out of them. I’ve done some research but didn’t find anything. Here’s what I have: a Pioneer VSA-E03 receiver, a Panasonic Blu-ray player DMP-BD60. I connected the Blu-ray via optical since it doesn’t have 5.1 outputs and the receiver doesn’t have HDMI.

My problem is that according to the manual, I can see how to connect to obtain Dolby, but not the hookup for 5.1.

Thank you for your help

Configuration: Windows 7 / Firefox 3.5.6

2 answers

  1. tarascon4
     
    Hello,

    the Dolby is 5.1, configure the DVD and the receiver on the optical input source.
    1
  2. Taliesin56 Posted messages 45 Status Member 12
     
    Is that it?! So once I’ve plugged it in as shown in the diagram for the Dolby, it’s good. Then it’s just a setting to adjust if I understood correctly?
    0
    1. tarascon4
       
      exactly HDMI on an amp is just a simple way to transfer the sources to the TV player recorder exactly
      0
    2. Taliesin56 Posted messages 45 Status Member 12
       
      thank you very much. I will therefore test the settings then.
      0