Batch and access path
Leahkim
Posted messages
3219
Status
Member
-
floxi Posted messages 153 Status Member -
floxi Posted messages 153 Status Member -
Hello,
here is the very simple content of my batch:
echo off
net use T: "\\srvqual\14-Materiel C6 des ressorts"
pause
I want to map this shared folder on a workstation, but when I run it, it says:
"path not found"
the address is correct, when I type it in Run it works. Why?
here is the very simple content of my batch:
echo off
net use T: "\\srvqual\14-Materiel C6 des ressorts"
pause
I want to map this shared folder on a workstation, but when I run it, it says:
"path not found"
the address is correct, when I type it in Run it works. Why?
Configuration: Windows XP Opera 9.51
4 answers
-
Thank you for your response, but...
CMD.EXE has been started with the path as the current directory. UNC paths are not supported. Using the default Windows directory.
C:\WINDOWS>echo off
System error 53 has occurred.
The network path was not found.
Press any key to continue...
Here is the error I'm getting.