View original (French)

Managing HP ProCurve 2510 Switch (CLI)

Kalvin91 Posted messages 8 Status Member -  
 invité -
Hello,

I just received an HP ProCurve 2510 switch. I would like to configure it to assign an IP address and manage it via my web browser.

I am trying to access it using my serial cable and HyperTerminal software, but nothing works... I can't get to the config screen of my switch... :'( I am on Win2k3.

How can I do this??? What am I doing wrong???

Thank you in advance :)
Configuration: Windows XP Internet Explorer 7.0

5 answers

  1.
    patrontueur Posted messages 9 Status Member 31
     
    On my site, I have put a small documentation to manage HP switches
    http://notionsinformatique.free.fr
    administration section
    21
    1. denis
       
      Hello,
      Great your site.
      I've been looking for a tutorial for HP sw for a long time.
      Thank you.
      1
  2. Greg
     
    Hello
    I want to take control of my HP 2810 Switch to configure it...
    I don't have the Console cable.. Can we connect via HTML page??
    How can I find its default IP?
    With Cisco, there is a default accessible IP address, is it the same with HP?

    Thank you

    Greg
    3
  3. Kalvin91 Posted messages 8 Status Member 2
     
    Problem solved by itself :)

    Change the bps in the settings of COM1 port and it works :)

    Except now, I would like to implement a MAC address restriction on the switch.

    Only allow the MAC addresses entered in it to pass through the switch.
    2
  4. Exodus2127
     
    Hi,
    Could you tell me more about the serial port settings to connect to the switch? I have the same issue.
    2
    1. xtro74
       
      Il faut que ton terminal soit configuré comme suit :

      19200 baud rate
      8 bits data
      parité : aucune
      1 bit de stop
      flow control : Xon/Xoff

      Tu peux faire ces réglages soit en passant par le gestionnaire de périphériques en sélectionnant le port COM que tu vas utiliser, soit dans le menu setup/serial port de TeraTerm, en espérant t'avoir un peu aidé.
      0
    2. invité
       
      On all the sites, the baud rate is set to 9800 and there is no flow control.
      0