Managing HP ProCurve 2510 Switch (CLI)
Hello,
I just received an HP ProCurve 2510 switch. I would like to configure it to assign an IP address and manage it via my web browser.
I am trying to access it using my serial cable and HyperTerminal software, but nothing works... I can't get to the config screen of my switch... :'( I am on Win2k3.
How can I do this??? What am I doing wrong???
Thank you in advance :)
I just received an HP ProCurve 2510 switch. I would like to configure it to assign an IP address and manage it via my web browser.
I am trying to access it using my serial cable and HyperTerminal software, but nothing works... I can't get to the config screen of my switch... :'( I am on Win2k3.
How can I do this??? What am I doing wrong???
Thank you in advance :)
Configuration: Windows XP Internet Explorer 7.0
5 answers
-
On my site, I have put a small documentation to manage HP switches
http://notionsinformatique.free.fr
administration section -
Hello
I want to take control of my HP 2810 Switch to configure it...
I don't have the Console cable.. Can we connect via HTML page??
How can I find its default IP?
With Cisco, there is a default accessible IP address, is it the same with HP?
Thank you
Greg -
Problem solved by itself :)
Change the bps in the settings of COM1 port and it works :)
Except now, I would like to implement a MAC address restriction on the switch.
Only allow the MAC addresses entered in it to pass through the switch. -
Hi,
Could you tell me more about the serial port settings to connect to the switch? I have the same issue.-
Il faut que ton terminal soit configuré comme suit :
19200 baud rate
8 bits data
parité : aucune
1 bit de stop
flow control : Xon/Xoff
Tu peux faire ces réglages soit en passant par le gestionnaire de périphériques en sélectionnant le port COM que tu vas utiliser, soit dans le menu setup/serial port de TeraTerm, en espérant t'avoir un peu aidé. -
-
-
do you have his ip? open it from your IE:
http://1..................