View original (French)

Swa7000

Duf24 -  
baladur13 Posted messages 47346 Registration date   Status Moderator Last intervention   -
Hello, I can't connect the swa7000 module to my home theater ht-j5550w. Is there a procedure? I still have the blue light blinking
Thank you for your responses

Configuration: Android / Chrome 49.0.2623.108

3 answers

  1.
    baladur13 Posted messages 47346 Registration date   Status Moderator Last intervention   14 397
     
    Good evening,
    Excerpt from the HT-J5500W manual page 12 
    If the device does not establish a wireless connection, you need to perform an ID pairing between the device and the wireless receiver module. 
    Turn off the device, then press the "0", "1", "3", "5" buttons on the remote control. Turn on the wireless receiver module. Then, press and hold the "ID SET" button located on the back of the wireless receiver module for 5 seconds. 
    Finally, turn the device on.

    The manual: https://downloadcenter.samsung.com/content/UM/201504/20150427134400807/HT-J5500_J5550W-ZF_AH68-02799C-00L04_20150420.pdf

    -- 
     Very difficult to catch a black cat in a dark room.
                                  Especially when it's not there...
    0
  2. DUF24
     
    Thank you for your response, but that's what I did. The home shows "wireless link ready," then I press idset for 5 seconds and turn the home back on, but the swa7000 is still blinking. For your information, it starts blinking as soon as I power it on. Is that normal?
    0
    1. baladur13 Posted messages 47346 Registration date   Status Moderator Last intervention   14 397
       
      The procedure given in the previous message... is intended for the case where the pairing does not occur... which seems to be your situation.

      Starting from a module that is not functioning, it is indicated to turn off the home (it therefore cannot display "Home link ready").
      Once this is done, you need to enter the code 0135 using the remote control.
      Power on the wireless module...
      Press the "ID set" button for 5 seconds.
      Then, turn on the home.
      0
  3. DUF24
     
    Thank you again for your response. Should I put the home device in standby before doing 0,1,3,5, or do I need to unplug it from the power source? Because when I leave it in standby and perform the procedure, it shows "wireless link ready" and after 5 seconds on ID SET, I still have the blue light blinking. Note: when I unplug the SWA7000 from the power source and plug it back in, instead of having the red light, I immediately have the blue LINK light blinking.
    0
    1. baladur13 Posted messages 47346 Registration date   Status Moderator Last intervention   14 397
       
      Watch or disconnected sector?
      The manual I found is too quiet about this pairing phase...
      I didn’t find anything describing the normal procedure, nor even a description of this flashing indicator.

      That said, is your wireless receiver module not too far from the home?
      It’s best to carry out the pairing procedure with both of them side by side.
      0