## 343

bonjour j'ai trouvé ça pour vous mais en anglais

The error code ##334 represents a printer control error, specificaly an EEPROM check error. The manual indicates that this means the Printed Circuit Board may need replacing, however, try this procedure.
Insert paper into machine.
1)To enter service mode press Menu, copy, #
2) Select Test Mode with the + or - keys
3) Press OK
4) Press 8, lcd shows 'Please Wait', after wait, press 3, the lcd then alternates between 3-0 (EEPROM clear, this normally is used to reset the Waste Ink Tank Near Full message but may just rectify your problem), and 3-1 (Purge flag)
5) When EEPROM clear (3-0)shows, press 0, then OK, then Stop then press the OFF button.
Start again at step 1, in step 4, this time reset the Purge flag by pressing 0, OK, Stop, Off.
If the red fault light is still blinking press Resume.
Hope this helps.

cordialement

Sussi