Imsensors Linux

Bonjour, Je vien tout juste D'installer imsensors pour pouvoir connaitre la temperature de mon laptop et aussi pour controler la vitesse de mes fan. Don quand jouvre imsensor une fenetre blanche saffiche.Jai lu quil faillait faire un sensors detection alors je lai fait mais il semble quil ne trouve aucun capteur , voici ce quil me donne

Client found at address 0x50
Probing for `Analog Devices ADM1033'... No
Probing for `Analog Devices ADM1034'... No
Probing for `SPD EEPROM'... Yes
(confidence 8, not a hardware monitoring chip)
Probing for `EDID EEPROM'... No

Probing for `National Semiconductor LM78' at 0x290... No
Probing for `National Semiconductor LM78-J' at 0x290... No
Probing for `National Semiconductor LM79' at 0x290... No
Probing for `Winbond W83781D' at 0x290... No
Probing for `Winbond W83782D' at 0x290... No
Probing for `IPMI BMC KCS' at 0xca0... No
Probing for `IPMI BMC SMIC' at 0xca8... No

Probing for Super-I/O at 0x2e/0x2f
Trying family `National Semiconductor'... No
Trying family `SMSC'... No
Trying family `VIA/Winbond/Fintek'... No
Trying family `ITE'... No
Probing for Super-I/O at 0x4e/0x4f
Trying family `National Semiconductor'... No
Trying family `SMSC'... No
Trying family `VIA/Winbond/Fintek'... No
Trying family `ITE'... No

Silicon Integrated Systems SIS5595... No
VIA VT82C686 Integrated Sensors... No
VIA VT8231 Integrated Sensors... No
AMD K8 thermal sensors... No
AMD K10 thermal sensors... No
Intel Core family thermal sensor... No
Intel AMB FB-DIMM thermal sensor... No

Sorry, no sensors were detected.
Either your sensors are not supported, or they are connected to an
I2C or SMBus adapter that is not supported. See
http://www.lm-sensors.org/wiki/FAQ/Chapter3 for further information.
If you find out what chips are on your board, check
http://www.lm-sensors.org/wiki/Devices for driver status.

Donc il me detecte seulement une chose,jessaye donc un autre code 'sensors' et voici ce quil me donne

nick@ubuntu:~$ sensors
acpitz-virtual-0
Adapter: Virtual device
temp1: +58.8°C (crit = +114.8°C)

donc si il me donne la temperature il doit y avoir un sensors
Alors je ne sais pas quoi faire avec sa, imsensor reste sans réponse et jaimerais pouvoir controller mes fan .
Jai aussi essayer de modifier la vitesse des fan depuis le bios mais je ne peut pas.

donc si quelqun a la solution a mon probleme je vous remerci d'avance!