Wall socket RJ45 not communicating with box
Solved
Hello,
I can't get my wall RJ45 socket in the living room to communicate with the box where my Bouygues box is connected.
I'm on VDSL, there is no fiber, I connect my gray ADSL socket to the box to the DTI test socket, and then I connect an Ethernet cable from my box to the splitter (where the octopus is originally plugged), but it doesn't communicate.
Attached are some photos.
Thank you!
I can't get my wall RJ45 socket in the living room to communicate with the box where my Bouygues box is connected.
I'm on VDSL, there is no fiber, I connect my gray ADSL socket to the box to the DTI test socket, and then I connect an Ethernet cable from my box to the splitter (where the octopus is originally plugged), but it doesn't communicate.
Attached are some photos.
Thank you!
6 answers
-
Problem solved, the wires of the RJ45 socket in the living room were not clipped properly, so there was no contact and no power. I clipped them firmly and it works!
-
I should mention that I dismantled the RJ45 socket in the living room and it is indeed connected with 8 wires.
-
-
ModeratorHello,
Above the DTI in your first photo, we can see 3 RJ45 sockets
Apparently, these are the sockets connected to the sockets in the rooms. This is where you need to connect 3 patch cords to the yellow sockets of your box
A photo showing these RJ45 sockets (view from below) above the DTI would be welcome...
Where is your box installed? Close to the DTI?
Very difficult to catch a black cat in a dark room.
Especially when it’s not there... -
Hello.
Okay, but where does it go on the electrical panel because I only see a phone splitter?
A phone splitter is wired with 4 wires, and for a computer network, you need 8.
.
In the electrical panel, it would be better to install a gigabit switch with 5 or 8 ports and connect to it. -
Your setup should look like this :
