dioumsamba
Messages postés85Date d'inscriptionlundi 28 février 2011StatutMembreDernière intervention20 février 2013
-
Modifié par dioumsamba le 7/03/2011 à 19:30
je rencontre des difficultés au niveau de mon serveur radius sur 2003 depuis déjà quelques jours après avoir configurer mon swtich 2950 voici le resultat de ma confg
NEDGEPS(config-if)#do sh run
Building configuration...
Current configuration : 1352 bytes
!
version 12.1
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname NEDGEPS
!
aaa new-model
aaa authentication dot1x default group radius
!
ip subnet-zero
!
ip ssh time-out 120
ip ssh authentication-retries 3
!
spanning-tree mode pvst
no spanning-tree optimize bpdu transmission
spanning-tree extend system-id
dot1x system-auth-control
!
!
!
!
interface FastEthernet0/1
switchport access vlan 2
switchport mode access
dot1x port-control auto
spanning-tree portfast
!
interface FastEthernet0/2
switchport access vlan 2
switchport mode access
dot1x port-control auto
spanning-tree portfast
!
interface FastEthernet0/3
!
interface FastEthernet0/4
!
interface FastEthernet0/5
!
interface FastEthernet0/6
!
interface FastEthernet0/7
!
interface FastEthernet0/8
switchport access vlan 2
!
interface FastEthernet0/9
!
interface FastEthernet0/10
!
interface FastEthernet0/11
!
interface FastEthernet0/12
switchport access vlan 2
!
interface Vlan1
no ip address
no ip route-cache
shutdown
!
interface Vlan2
ip address 192.168.1.5 255.255.255.0
no ip route-cache
!
ip http server
radius-server host 192.168.1.10 auth-port 1612 acct-port 1813 key rad123
radius-server retransmit 3
!
line con 0
exec-timeout 0 0
line vty 0 4
password cisco
line vty 5 15
password cisco
!
!
end
ma question est:
lorsque je branche le câble entre le pc-switch-serveur sa ne fonctionne pas mais je viens d'installer mon serveur